DIY Amplifier Darlington 2N3055 Transistor Extremely powerful Using Output Capacitors

Hello guys, this is a class A amplifier circuit using transistors 2N3055 and C2073 paired Darlington, the circuit for quite a high amplification factor gives extremely powerful sound.
This is the simplest circuit, easy to find components.
Thank you for watching the video and for supporting me. Good luck.
.................................................. ...........
Diagram: bit.ly/2pelboT
.................................................. ...........
Amplifiers use:
2n3055 Transistors x 1
C2073 Transistors x 1
Resistor 33K / 1W x 1
Resistor 10 Ohm / 10W x 1
Capacitor / 220uf / 50v x 1
Capacitor 4700uf / 25v x 1
Pot 50k Potentiometer x 1
Power Jack DC x 1
DC converter 12v / 3A x 1
Aluminum heat sink x 1
3.5mm phone jack
..................................................
*Subscribing to the channel so that you don't miss the latest videos:
www.youtube.co...
______________________________________
****Video you may not have watched****
*DIY Class A Amplifier Using C5200 Transistor Extremely Powerful:
• DIY Class A Amplifier ...
*Diy Simple Three Transistor Class-AB Audio Amplifier:
• Diy Simple Three Trans...
*How to Make Simple Amplifier With Transistor PNP, Dual Speakers Connect:
• How to Make Simple Amp...
*Diy Amplifier Extreme Powerful Bass With Quad Transistors 2SA1943:
• Diy Amplifier Extreme ...
*Diy Amplifier Circuit Using Transistors 13007 From The Old Computer Power Supply:
• Diy Amplifier Quad 130...
*DIY Class A Amplifier 2SC5200 Transistor Extremely Powerful Using Output Capacitors:
• DIY Powerful Ultra Bas...
*DIY Amplifier simple 2SA1943 and 2SC5200 Transistor Extremely Powerful Using Output Capacitors:
• DIY Amplifier simple 2...
*How to Build 30W Mono Amplifier With IC NE5532:
• DIY 50W Mono Amplifier...
*DIY Amplifier Class A Stereo Extremely Powerful Using Output Capacitors: • DIY Amplifier Class A ...
*Diy Amplifier Stereo Class A Extremely Powerful Using Transistor H1061 Output Capacitors:
• Diy Amplifier Stereo C...
*DIY Amplifier Darlington 2N3055 Transistor Extremely powerful Using Output Capacitors:
• DIY Amplifier Darlingt...

[@ShareTechCreative]

Diy class A amplifier mono powerful with transistors 2N3055 & C2073, output speakers using capacitors

[@Madmaxkkb]

Can I use 1/4 watt resistors..? Plz reply

[@CBTman99]

Very simple and effective single ended power amp. Using it with a cellphone gives it not only enough signal to sound well, but it also provides tone control, as a pre-amp would do. Using an output capacitor protects the speaker coil without much reduction of bass tone, it seems. Construction wide, I would use a solder lug for the connection to the transistor's collector to improve efficiency and strength. In addition, I would keep the C2073 as far from the 10 W resistor as possible to avoid temperature drift. Great evening project!

[@ShareTechCreative]

Thanks very much

[@wcmm1970]

right, I agree with the explanation. the problem will be to unite those of the output transistors in the double potentiometer

[@shoaibmirza2402]

Wahoo. Great technical thing u manage baising this circuit never gos over heat because ur base resistance connected with collectors of darlington

[@ShareTechCreative]

Yes, you are right

[@Hasitha668]

yes

[@wcmm1970]

I did one and the sound quality is great

[@ShareTechCreative]

Congratulations

[@xorochi2183]

So
Super!👍

Bộ loa tốt đó bạn cách sửa hay đó bạn

[@ShareTechCreative]

trung phan Miền tây
Thanks, bro

[@joeyscott4299]

Very Nice Design ! I've been wanting to try a darlington amp , thank you for continued inspiration my friend !

[@ShareTechCreative]

Joey Scott
Thank you very much

[@tgtube]

Lk 81 very nice info big likes thanks dear 🙏

[@INNOVATION_CRAFT_TECHNOLOGY]

How many watts and how many ohms does the speaker use?

[@user-tz5gb7kw8z]

👍👍👍👌super👋

[@eoliver32]

Nice!

[@topquark22]

This is extremely cool. Will build! Thank you!
Q: What is the model of heat sink to fit a TO-3 case transistor?
Thanks.

[@phitrow]

I designed this when I was in grade 8-9, it was in the early 90s.

[@user-lm3zu2ec9r]

Good

[@ShareTechCreative]

Thanks

[@abhishekverma1977]

hello, i am impressed with your work and knowledge, do you have any circuit like guitar amplifier "stranger cube 20", transistor based

[@ShareTechCreative]

You can watch it here: czcams.com/video/eYw17LG8LV0/video.html

[@saeidamirkashani2978]

Hi Sir,
Thanks for sharing videos.
Kindly please can any body help me to understand why when the circuit is on and the high amper circulate through
emiter and collector which is installed on metal heat sink and no short circuit happens and why some use thermal
paste and some not?

[@joeyscott4299]

Seems like all good people here:)

[@ShareTechCreative]

Joey Scott
*And I also have all great friends here :)*

[@wcmm1970]

I managed to find, thanks

*Darlington DIY Transistors amplifier is very interesting! Lk have fun!*

[@jozsefbodor333]

👍

[@gilbertomunos803]

quedaria mucho mejor si colocaras el plano de circuito gracias

[@marianotorrente]

How many watts can RMS support?

[@xorochi2183]

👍👍👍

[@ShareTechCreative]

Thank you!

[@wcmm1970]

hello, good morning, it would be possible to place 2 transistors, the 2 connected to a double potentiometer using the same design

[@ShareTechCreative]

You make an analog circuit into a stereo amplifier. If so, you need to pay attention to the use of mica to insulate the transistor, or you use two separate aluminum radiators to not touch each other, to avoid damaging the transistors.

[@dipaksardar1909]

How woofer size and watts?

[@alaminmuhammed4137]

Is using a heat sink compulsory or can one use a Vero board?

[@globalcomsur]

How much watt is this amp.

[@Nirky]

.090 A x 12v = 1.08 W power consumed. Class A great sounding but very inefficient, so maybe 300-400 mW output? Need 96+ dB speakers and a very small room.

[@cursinoprs]

Hi. Good morning. Does anyone knows how many Watts we have in this Amp, please? Tks in advance.

[@bhre-sports4015]

How much voltage can we give the amplifier to get maximum output wattage ?????

[@NotCaily]

it depends on you're capacitor And Transistor

[@angelgrisales4644]

Buenas amigo espero este bien... Le puedo instalar otro transistor 2n3055 en paralelo ?

[@ShareTechCreative]

Sí, pero debe aumentar la resistencia de 10 Ohm / 10W a 10 Ohm / 20W y agregar un disipador de calor de aluminio

[@jayjorolan1463]

Can I replace the 10 ohm 10 watt resistor into 12 ohm 10 watt?? Please answer

[@ShareTechCreative]

Yes can

[@marioburton9927]

Que potencia de salida tiene?

[@geoathan1]

Can I use to replace C2073 with BD237 or BD139? I ask specifically for BD237, because I have some in my drawer.

[@ShareTechCreative]

Yes, can two-transistor

[@wcmm1970]

hello, could you make one with 2 2n3055 and your pair mj2955. the guys from Brazil. thanks. (pandemic) very bad here only making amplifiers. thank you

[@ShareTechCreative]

I can try

[@libmananchannel]

Very nice! Great DIY information! Thank you my friend!

[@plodoviprirode]

50. Like

[@ShareTechCreative]

Plodovi Prirode
Thanks, my friend!

[@twmodule9157]

✔️

[@hugosiguenasrojas8991]

Mi estimado buenos días no lleva la mica o el aislante el transistor gracias

[@ShareTechCreative]

Because of the mono amplifier circuit, if you make stereo amplifier, you need them
Thank you very much👍

[@marioraziel696]

No lleva puesto k solo es un transistor pero x las dudas al aser el circuito ponle mika y su buje

[@wcmm1970]

hello, good night, what is this c2073 transistor, its class in the datasheet.

[@thuyvlog2496]

hướng dẫn làm bộ thiết bị điều chỉnh tăng giảm âm lượng nhìn đơn giản mà hay quá

[@loanloan7238]

Hi new friend nice meet you.!!! thank you for visiting my blog.
I subscribed and put like on your blog. see you again. good luck~~~~
Loan Loan

[@ShareTechCreative]

Thank you, good luck

[@krystiankitka5856]

what wattage is the resistor or resistor?

[@renikuntlasachikethmeru2911]

Can we control volume by 50k potentiometer?

[@ShareTechCreative]

Good use 50k potentiometer

[@Spesialisreffdiditslaw]

Saya menggunakan speaker subwoofer 6 inch 8ohm
Suaranya sember tidak bulat,masukannya dong hrus diapakan biar basnya nendang saya menggunakan psu 12vdc5a

[@outdoorlifethailand]

😊 Like 57 for you my friend👌👍👍👍👍

[@ShareTechCreative]

ไต๋แขก โชคกิตติพงษ์
Thanks, bro

[@simabu5842]

Nice but provide the circuit diagram please encourage

[@ShareTechCreative]

Diagram: bit.ly/2pelboT

[@ksssaja6994]

What size speaker is uncle

[@wcmm1970]

hello, good night, I could try making an amplifier with 2n3055 and mj2955. and post.

[@sumoda.subrannian8075]

Can you she the circuit diagram of a mono amplifier using 2 x 2n3055 bridge for Sub woofers

[@nimmyrose5987]

Can u make an amp like this with mosfet K3473 please

[@wcmm1970]

hello, good morning, would you like to make this amplifier with 2 transistors

[@ShareTechCreative]

Yes we can

[@vutranvan9268]

Like

[@hiiamtonytonychopper9161]

how many watt are this amp !

[@johnjeson3052]

BRAVO U MADE AN AMP BUT A CIRCUIT COULT HELP

[@s.d.arunarohitha5676]

What other transistors can be used to replace the C2073?

[@ShareTechCreative]

TIP41, C4793, C5171...transistors

[@hugosiguenasrojas8991]

Podrá resistir un voltaje de 18 voltios dc

[@ShareTechCreative]

hugo sigueñas rojas
No, using 12VDC
You must polarize the transistor to use the 18V voltage

[@bambangekopurnomo9695]

Berapa volt berapa ampre model power supplay nya gimana

[@ShareTechCreative]

DC 12 volt 3 ampere

[@NotCaily]

so i made one myself it works but its always humming is there a way to fix it?

[@ShareTechCreative]

It may be due to the power supply unit, you try to use the adapter power

[@NotCaily]

you mean a switch mode power supply im not sure if i even have one that can supply the current

[@marioguerrero3855]

And the diagram ?

[@ShareTechCreative]

Check description

[@koratmember]

Thank you so much, Can I use two of 2N3055 and how to apply?

[@balancristian9389]

not even 1 Amp at 12V?? it means less than 12W....

[@wcmm1970]

2SC2073 Bipolar Transistor ok.

[@ProMaker123]

microphone with echo and volume pre-amp making video

[@amit44s56]

Sound is good give detels about power supply, and speaker out put

[@parmarpitambarbhai4889]

2n 3773 ki jagah es ka estamal ho sakta hy

[@ShareTechCreative]

Yes, you can

[@parmarpitambarbhai4889]

@@ShareTechCreative Thanks....
Gaurang DJ sound odhav Ahmedabad Gujarat

[@josecarlosdossantosjose5457]

Gols rei legau

[@wcmm1970]

this one, that you did I use all day, but I can't marry the union of your couple mj2955

[@nestorjoserodriguezgarcia5221]

Cual es la conexión para hacerlo estereo

[@nestorjoserodriguezgarcia5221]

Paseme el esquema estéreo por favor

[@ShareTechCreative]

Construyes dos circuitos amplificadores idénticos

[@wcmm1970]

HC2073 Datasheet (PDF) - SHANTOU HUASHAN ELECTRONIC DEVICES CO.,LTD

[@vicenterosero6729]

NO SE VE BIEN ...EL CIRCUITO

[@ShareTechCreative]

Schematic diagram links in the description

[@wcmm1970]

KSC2073H2TSTU

[@shaifulbahri1365]

output watt？？？？

[@ShareTechCreative]

More than 15 watts RMS

[@shaifulbahri1365]

@@ShareTechCreative 150 watt

[@s.d.arunarohitha5676]

What other transistors can be used to replace the C2073?

[@ShareTechCreative]

TIP41, C4793, C5171...transistors