In the design software, you need to set the sewing order to do the center letters first, e.g., Iced Tea would be d,T, (1st)e, (2nd)e,c,a,I. Basically your center letters, working back and forth, right, then left, to the outer letters. It’s easy with lettering, less so for designs, but the same concept. I hope that this helps, if not you, someone else.
I struggle with letters on hats. What's the best font or smallest size? Mine looks 'blurry' for lack of a better word. The letters are just not crisp. This was a great video! Very informative!
I noticed it looks like you took the holder for the cap bill off. Mine hits the back of my machine and I don’t see any adjustment. Is it ok to remove it?
What is the name of hat hoop with the small metal piece on the front? Mine has a wide, grey, plastic piece that goes on front of hat and I can't get my designs low enough.
Thank you for this tutorial.
THANK YOU FOR SHOWING THE 2 BACK SCREWS ON TOP !!!
I was screwing the small screws in the center holes which my machine Hated !!!!
This was the best video yet, short sweet and to the point, I learned more in ten minutes…
Thank You!
This is a wonderful tutorial!! Thank you so much for the step-by-step process!
Thank you so much! This is a great video!
Thanks for the tutorial. I got lost with the “sewing the design inside out and it’s done in the software”.
In the design software, you need to set the sewing order to do the center letters first, e.g., Iced Tea would be d,T, (1st)e, (2nd)e,c,a,I.
Basically your center letters, working back and forth, right, then left, to the outer letters.
It’s easy with lettering, less so for designs, but the same concept.
I hope that this helps, if not you, someone else.
I struggle with letters on hats. What's the best font or smallest size? Mine looks 'blurry' for lack of a better word. The letters are just not crisp. This was a great video! Very informative!
I did not see you Attach the needle plate spacer to the needle plate like my owners manual indicates
I noticed it looks like you took the holder for the cap bill off. Mine hits the back of my machine and I don’t see any adjustment. Is it ok to remove it?
what if I don't want the design in the middle? I am wanting to put mine to one side.
how do you make sure its sewed Center Out? what do you do?
How can I get my logo to see lower to the bill of the hat. It won’t go any lower than an inch.
My machine does not recognize my hat hoop jig once installed. Plus it says charring to a big frame. I have a PR600II please help me
That’s what my babylock 6 needle is doing. Did you ever figure out the issue?
That was very helpful. Does the machine need servicing if it gets out of alignment because the top screws and bottom screws hit?
We are having an issue with the hoop popping off the driver. Usually on flat billed hats. Any suggestions?
How do you rotate the hat for side embroidery
I use a quick clamp for sides and back.
I can't seem to set my 1050X to embroider on the left side of the front panel instead of center of front.
What is the largest design you can put on a cap with the 6 needle cap system?
What is the name of hat hoop with the small metal piece on the front? Mine has a wide, grey, plastic piece that goes on front of hat and I can't get my designs low enough.
How do you adjust the hat hoop if your hat does rub?
Where is your shop located?
Where are you located, state/city?
We are in Shreveport Louisiana
Thank you only 5 hours away
why is the video so fuzzy?