4.8 LS swapped colorado
Vložit
- čas přidán 12. 06. 2022
- finally Got this thing moving under its own power. had to sound check the equal length Y pipe before I finish the exhaust. this is open Y, and 6 inches of collected 3" straight.
gen 4 4.8
milled 862s
226/232@.050 cam
4l80 3500 stall
speed daddy midlength C10 headers
custom equal length Y ( open and dumped for tonight)
more videos to come! - Auta a dopravní prostředky
This rowwwdddyyy. I love it.
Damn nice truck, sir.
This truck is badass. I got the same one but black I plan on doing the same swap! Hopefully it sounds this good once im finished.
Sounds great
Care to share how much you milled the heads? And push rod length? Truck sounds amazing! Excellent work!
.030. Using morel lifters, I was still able to get away with 7.400 pushrods surprisingly.
I did the same with 706 heads and valve/port work and ss3 cam victor jr intake.Your tune is a lot closer then mine is. Mine dosent rev up like that and breaks up when you try too but I hope to have it like yours one day.
What’s the exhaust set up? Sounds great! Is it 4-1 headers with a Y and single pipe?? Or a X pipe and dual tip?
4-1 headers, equal length Y, and a single pipe out back
Awesome thank you! Any mufflers??
Any more vids?
Just got it buttoned up and ready for the tuner yesterday. Will have more vids next week!
@@GTPonYOU1 we demand more vids my guy!
What transmission you running?
4l80 with a precision industries 3500
Nice, what did you do for headers/manifolds? What cam are you running?
Speed engineering midlength C10 headers. Couple small dents.
Chinese copy of a Howard's 226/232. Ran it in my TBSS for 2 years until I switched to a BTR truck cam. Had it laying around :)
@@GTPonYOU1 nice. I have been trying to think of an inexpensive way to do my exhaust.
@@billsibert7922 I couldn't ask for a better fit with the speed engineering c10 mids. 1/4 the price of application specific headers...sometimes good enough is good enough.
Curious about the exhaust setup.
What exhaust header are yall using
Speed engineering mid length C10 swap headers with a custom equal length Y collector that I made.
@Steve H can u show pics of how u installed them and were u had to dent it to make it fit mine hitting the steering wheel shaft ?? I bought a set
@@keithlozano9235 I took the steering shaft loose, installed header, and hooked it back up. Just had to dent around the motor mounts a little, and a small dent on passenger floor to clear the Vband I welded on. You might need to adjust motor mounts or play with trans mount height a little, but they went I. Super easy. I have maybe an hour into install.
@Steve H I'm using fabbot motor mounts
I have them set as far front as I can go and I cut the ears of the factory motor mounts to make clearance
What cam ??
An old howards 190325-12
What's hanging below the motor, a 4.8 nutsack?
The stock power steering pump. Just tied it out of the way to get the truck moved out of the shop without barfing the contents of the rack... I have since made new lines to use the LS pump.