Best Install Methods: How to Install Hansshow Display Tesla Model 3 & Y HUD No blocking air vent!
Vložit
- čas přidán 7. 09. 2024
- Hey guys. When asked what about which features are missing from Tesla Model 3 and Model Y, many will say things like a traditional gauge cluster behind the steering wheel, and Apple CarPlay
So Here are Best Install Tips and Methods for Hansshow Display Cluster. Hope you enjoy the video. we try to make sure that the video is under 10 minutes for the installation and give you the best advice and location for the screen
Product link
amzn.to/3FVD7ph
Discount Code: 05FTA8RN
Don't forget to like and subscribe for more content.
My Gear:
Camera: DJI Osmo pocket camera tinyurl.com/bu...
Panasonic GX85 Mirrorless camera tinyurl.com/Pa...
Mic: Rode Wireless Go tinyurl.com/bu...
GoPro Hero 10: amzn.to/3AY1zEh
We may get revenue from CZcams ads and we do get a small affiliate fee with each purchase.
#FastReviews For product reviews please send products/information to:
RKS
PO BOX 611240
San Jose CA 95161
Hi
Could you please share how you routed the cables with your upper mount not blocking the air vents ?
what has to be dismounted and where cables are going through to reach the side panel on the right where ODB port is ?
The updated 2022 9” version of this product no longer supports the front camera. Updated 9” has a smaller bezel than the original 8.8” to block less air flow. If you were choosing a display system today would you go with the small bezel 9 inch with no-camera or the 8.8 inch with front camera? Front camera is nice and low, automatically turns on when front sensors go off and the first seconds of drive which is pretty cool.
I suspect this doesn’t work on the newer hansshow 9” display. Web site says it has no front camera support but has wireless Apple CarPlay.
I purchased this display as well. Question???
Are you having issues with calls? Every person I talk to says they hear an echo when they speak until I turn off the CarPlay connection? Any simple workarounds other then disabling the connection?
Hi. Which software version you have?
Nice work!
Just started to view your installation video. Is it easier to access the OBD port the way you installed it or the previous way were you face up under the dash? I installed one in the past (2 years ago) and it was very difficult to access the OBD port.
Thank you
It’s actually easier to install by removing the glove box. Little more work but much easier to plug in