Helium - 05 Antenna Upgrade | INSANE RESULTS | 137 Witnesses! [ 5.8dBi to 8 dBi ]

Sdílet
Vložit
  • čas přidán 15. 10. 2021
  • A quick antenna changeout from 5.8dBi to 8dBi, yielding unbelievable results. Enjoy!
    Non-affiliated links:
    Lightning Arrestor (Pay close attention to the connector types!)
    Option 1: shop.parleylabs.com/products/...
    Option 2: Amazon. You'll have to buy the connectors based on your antenna type (N-Female or N-Male).
    www.amazon.com/gp/product/B07...
    ======================
    Connector Seal:
    Option 1: shop.parleylabs.com/products/...
    Option 2: Coax Cable Sealant Tape, 1/2 Inch by 60 Inch Roll www.amazon.com/dp/B00A7AXBSQ/...
    ======================
    Electrical tape super 33+:
    Scotch Super 33+ Vinyl Electrical Tape, 3/4 in x 66 ft, Black www.amazon.com/dp/B00004WCCL/...
    ======================
    8 dBi Antenna
    Option 1: shop.parleylabs.com/products/...
    Option 2: shop.parleylabs.com/products/...
  • Věda a technologie

Komentáře • 17

  • @dadude123equals5
    @dadude123equals5 Před 2 lety +3

    Great video! You should start a discord!

  • @tookey2249
    @tookey2249 Před 2 lety +2

    Make more helium related videos! They’re very helpful & informative

  • @creepy3973
    @creepy3973 Před 2 lety +2

    great videos bro!! love them

  • @julianfurtuna8582
    @julianfurtuna8582 Před 2 lety +1

    Good job!

  • @Airborn14
    @Airborn14 Před 2 lety +1

    Dang thats cool thanks for the vid

  • @danger_close5652
    @danger_close5652 Před 2 lety +1

    I thought you were supposed to calculate the dbi losses (due to cable and connectors) as mentioned in your antenna video when inputting it into helium ap?

  • @cv9726
    @cv9726 Před 2 lety +2

    Thanks for the video, great setup you have there! Do you have links for the equipment used?

    • @youngmaverick542
      @youngmaverick542  Před 2 lety

      Check out the video description. I've just updated it. Hope it helps.

    • @williamjonson6845
      @williamjonson6845 Před 2 lety

      @@youngmaverick542 do you know how to get an ubiquiti gateway setup for inbound port forwarding. I've set it up like the site says but it's still stuck in relay mode

    • @youngmaverick542
      @youngmaverick542  Před 2 lety +1

      @@williamjonson6845 Unfortunately, I don't have that gateway. From the site, it looks like it's just like most router where you first configure the Port Forward, then the Firewall. Be sure to reserve a local static IP first for your miner before those 2 items above. On some of my locations, I noticed that despite after the configuration the Helium Explorer & App are a bit behind on the 'display' with the relay indication because I did saw that the Port Checker says it was opened. Fortunately, I trusted the information from the Port Checker and waited up to 3 days on one of my install, where the relay status finally cleared. This may or may not apply to you, but I'd recommend running the port 44158 on a Port Checker (portchecker dot co or yougetsignal) to see if it's opened first. If it is, wait it out a bit before playing with more settings. If it is not, then it may be the mis-configuration on your end. Best of luck!

  • @Kryptoinsights
    @Kryptoinsights Před 2 lety

    Nice vids u should make more!

  • @dennishulsman567
    @dennishulsman567 Před 2 lety

    Did your hotspot also stop witnessing after the antenna upgrade and then took a long time to witness again? My hotspot Only sends out beacons without any witnesses. Its taking a long time 😂

  • @tookey2249
    @tookey2249 Před 2 lety +1

    Have you had any problems connecting the lightning arrestor directly into the antenna? I’ve done a fair bit of research and it’s leading me to believe that you shouldn’t do it that way.
    Would love to hear your thoughts, thanks!

    • @youngmaverick542
      @youngmaverick542  Před 2 lety +1

      Hey, what's going on? No, I've had not run into issues connecting it directly on the antenna on few of my installs. But you're absolutely right, THE textbook way is having it immediately before it enters your miner (i.e outside your window and creating an low resistance path to ground on the exterior in lieu of letting it enter your home). I did it slightly different because it worked for my circumstance.

    • @tookey2249
      @tookey2249 Před 2 lety

      @@youngmaverick542 Oh okay I see. Since you do get decent rewards I think I'll plug the lightning arrestor straight into the antenna and see how that works out for me.
      I had another question about the Transmit Scale. How are you getting the maximum 1.00 transmit. Is it because you are the only one in your "hex"?
      Also, could you please link the new antenna mount you used? Please and thanks!

    • @user-st1my2vh2i
      @user-st1my2vh2i Před 8 měsíci

      @@tookey2249 I can tell the absolute first thing you need to do is get the hotspot off the wifi. Hardwire the ethernet direct to your modem or router. I did this recently and the transmit scale is at 1.0 and the rewards are off the charts. Higher than anyone else around me. Standard antennae too. I am also the only one in my hex.

  • @xoHeretic
    @xoHeretic Před 2 lety +1

    Kind of insane you have a 1.0 reward with that many people near by. I have reduced rewards with much less people near by.