How to Remove Striker and Extractor for PSA Dagger Micro C 1 | The Easy Way!

This video shows you how to remove the striker and extractor for a PSA Dagger Micro C-1 for purposes of repair or maintenance only.
**This video is strictly only for repair or maintenance.**
If you're looking to buy a Kore Belt, use coupon code UBR10 to get 10% off your entire order.
Kore Belt Coupon Code: UBR10
Make sure to follow me on Rumble!!!
Follow me on Instagram @UBRArsenal
Subscribe for more UBR Arsenal content @UBR Arsenal
If you would like to support the channel, you can make a donation at paypal.me/UBRTech. All donated money goes directly to improving the channel and content.
Thanks for watching and don't forget to subscribe.
Disclaimer: These videos are strictly for educational and entertainment purposes only. Imitation or the use of anything demonstrated in my videos is done AT YOUR OWN RISK. All work on firearms should be carried out by a licensed individual and all state and federal rules apply to such. We (including CZcams) will not be held liable for any injury to yourself or damage to your firearms resulting from attempting anything shown in any of our videos. I do not endorse any specific product and this video is not an attempt to sell you a good or service. I am not a gun shop and DO NOT sell or deal in Firearms. Such a practice is heavily regulated and subject to applicable laws. I DO NOT sell parts, magazines, or firearms. These videos are free to watch and if anyone attempts to charge for this video notify us immediately. By viewing or flagging this video you are acknowledging the above.

[@SteveBlankenshipMedia]

Thanks, as always, for your videos. You're the most patient explainer I've found on CZcams!

[@UBRArsenal]

You’re welcome. I’m glad you found the video helpful. Thanks for watching and leaving a comment. Have a great day.

[@williammckeown9572]

Thanks a lot best part was when you went in reverse!!

[@UBRArsenal]

I’m glad you liked the video. Thanks for watching and leaving a comment. Have a great day.

[@mikewithers299]

Thank you for this. I've needed a video for this so I can clean the striker channel and extractor. 👍👍

[@UBRArsenal]

You’re welcome. Also, don’t forget to check your optic zero after you screw that optic screw back in. Thanks for watching and leaving a comment.
🤜🤛

[@mikewithers299]

@@UBRArsenal I'm not running an optic yet. Do I need to loosen the plate screw the same way?

[@UBRArsenal]

You shouldn’t need to loosen the screw to the plate. 👍🏼