Installing drive belt on craftsman garden tractor 
Vložit
- čas přidán 5. 09. 2024
- This is a craftsman garden tractor from the 90s. It is Hydro and we are putting a Drive build on. 
#Gardetractor
#Repair
#Gardentractorfrontendloader
#Lawnmowerrepair
#DIY
#CarryAll
#CraftsmanMower
#Wheelhorsegardentractor
#JohnDeere
#mowerrepair
#smallenginerepair
#lawnandgarden
#craftsmanlawnmower
Good job
Thanks, and thanks for watching
Very nice install . The drive belt came off my Husqvarna . I will be doing a video on that later today !!
Looking forward to it 😀
And keep
Cool
Me too, looking forward to it too
Good they put label for belt routing, a fella could get confused pretty quick.
Correct, the belt can go 10 different ways, I believe
Good work lee glad u were able to get it going again with the new drive belt. kohler engine sounds good on it also.
Thanks- it’s a smooth machine
Cool
Thanks for watching 😃
I have the same type of craftsman tractor, replaced the drive belt according to your instructions but the tractor does not move. The pin at the back of the tractor is engaged. Any advice on how to diagnose this problem?
Is your gears or Hydro?
It's a hydro
Are you familiar with the switch on the back that we will disable the Hydro from moving?
Yes I disabled the hydro so I could push the tractor. Then I engaged the hydro by lowering the pin.
How would I know if the transmission pump has failed? I was moving and the tractor stopped moving forward, I knew the drive belt had some cracks and was worn.
First time I did this on a Troybilt was a total disaster 👍🏽
I hope it wasn’t too bad, but one time I did this and put it in drive and it went backwards
These are easy to mess up