Geo Tracker no start repair, quick fix!

Sdílet
Vložit
  • čas přidán 8. 09. 2024
  • In this video i explain the diagnosis and repair of a 1995 geo tracker no start condition. Someone else had spent alot of time and money throwing parts at this without success. I show the diagnostic process i go through and the failed part I found using this process.

Komentáře • 20

  • @Red-yn9fv
    @Red-yn9fv Před 3 lety +2

    Very educational. I recently purchased a 95 geo from my mom. She parked it due to it not starting and when in went to hook up the jumper cables I found some of the nuts and bolts holding the positive wire on the battery were loose. I tightened them up and haven’t had any trouble since but after watching this video it made me think. I will probably check for corrosion on that resistor

  • @christophersteingart2237

    That's not the cause of my issue, however your video will help a lot of people.

    • @ChronCrew
      @ChronCrew  Před rokem

      Thank you, hopefully you get yours fixed soon.

  • @Dc_tech386
    @Dc_tech386 Před 3 lety +1

    Am having the same no start issues but the ignition is working the injector i test for a 12volt reading and the reading show 12 then 8 then 5 but i dont see the resistor connections you showing but i do see a 3 pin parts look like a resistor

  • @daniesteytler6847
    @daniesteytler6847 Před 3 měsíci

    Hi man Daniel here my car does the same if i spray fuel into the intake it starts, but the moment i stop spraying it dies, I did also test with noid lights on all 4 and do have continuous light on them flashing when cranking. It does look like the flashing on noid lights goes a little bit dimmer as I am cranking over, is this normal. Lastly my resistor like the one in video has only 3 pins with two measuring over 2000ohms but other two is just open line, I thinks i will replace that also and check it out from there.

  • @virginiagregg6193
    @virginiagregg6193 Před 3 lety

    My husband has a 93 Geo tracker he is having problem getting it to start most of the time. Has good battery and good starter (he says). He let the brake fuel run completely out, when he filled it up is when the problem started. We are bleeding the brakes to see if that helps. Can the problem be between the starter and the brakes?

  • @queenkaz9333
    @queenkaz9333 Před 3 lety +1

    I bought a 94 geo tracker that wouldn’t start we did all kinds of trial and error but there is just no power to the coil ! We’ve replaced the coil and still no dice it’ll crank just won’t start :/

    • @ChronCrew
      @ChronCrew  Před 3 lety

      No power to the coil primary circuit?

    • @queenkaz9333
      @queenkaz9333 Před 3 lety

      @@ChronCrew no power to the coil yes it will crank but will not start all the lights and everything works though

  • @Goodsnout
    @Goodsnout Před 3 lety

    With regard to the noise suppressor that you need to replace, where on the car does it mount?

    • @ChronCrew
      @ChronCrew  Před 3 lety

      It just hangs on the firewall underneath the wiper motor on the drivers side

  • @robormiston2841
    @robormiston2841 Před 3 lety

    I have a 95 Tracker and just put in a new starter and it clicks a few times befor it starts, brand new battery, and positive terminal and brand new starter. Any idea what to do next? I took it back to the store and they checked it out in the truck and it checked out good even though it took a few clicks to start.

    • @christophersteingart2237
      @christophersteingart2237 Před rokem

      If it's a manual transmission, there's a button under the dash that's depressed by the clutch pedal. It closes a circuit when depressed . It may need adjustment or replacement.

    • @vincentlavezzi7411
      @vincentlavezzi7411 Před 7 měsíci

      Which button? having this same issue on my 96 manual... No crank no start, not battery or starter, or alternator, ahhhh@@christophersteingart2237

  • @20havenfun08
    @20havenfun08 Před 3 lety +1

    Great video:) any luck finding one, part number?

    • @ChronCrew
      @ChronCrew  Před 2 lety

      I was unable to find this part, however making one using inexpensive resistors has proven to work without an problems.

    • @namerican8510
      @namerican8510 Před rokem

      11492-1105 this part ranges from 35 to 58 bucks

  • @EricRush
    @EricRush Před 6 měsíci

    Can't hear you even with volume turned up max.