Marco Melandri Aprilia SR50 Ditech Diagnosing 3; Boring you with a blinking light, will it run?

Sdílet
Vložit
  • čas přidán 24. 08. 2022
  • do the work

Komentáře • 10

  • @yamahateam2226
    @yamahateam2226 Před rokem +1

    Changé piston et cylindre....prision faible compression moteur 💯👂👍👆

    • @yamahateam2226
      @yamahateam2226 Před rokem +1

      With gasket

    • @yamahateam2226
      @yamahateam2226 Před rokem +1

      Im sure that your problème

    • @knetterman
      @knetterman  Před rokem

      @@yamahateam2226 Thanks for the comments,
      Check out the entire playlist for the full story.
      czcams.com/video/eYwl47gAP_U/video.html
      It ran,then broke again, but it is running again.
      czcams.com/video/yvYIQDXJqRY/video.html

    • @Reinekarlsson
      @Reinekarlsson Před rokem +1

      Hello, a lot of people make mistakes when it comes to these Aprilia SR 50 blinds, so they remove the cylinder head and don't know how to tighten these cylinder head nuts, that is, they tighten these nuts completely wrong Nm on the torque wrench it should be right on these Aprilia SR 50 should be a maximum of 10 Nm do not do this and also below this until finally here so you have to be very careful so that all the fuel hoses are whole and fine and last but not least here never take out this AIR INJECTOR which is in the cylinder head never does this often just becomes crap of reassembling it again and it doesn't work as it should and also listen to how your fuel pump you have on this moped how it behaves be careful with this and I would probably advise you to replace the starter motor with a brand new one you have tired

  • @StonedHardy040
    @StonedHardy040 Před rokem +1

    heey knetterman ik zag in dit filmpje dat je je bougie deed testen op et blok. Ik had ergens gelezen dat je je bougie zo niet moest testen want dan krijgt ecu of computer een opdonder waardoor ie kapot kan gaan ervaring mee ? misschien

    • @knetterman
      @knetterman  Před rokem

      Als je kan herinnneren waar je die info van hebt, zeg het gerust. Trek het sterk in twijfel, ben er inmiddel ook achter waarom deze scooter het niet doet hahah. Upload het vanavond.

    • @StonedHardy040
      @StonedHardy040 Před rokem

      @@knetterman ik krijg die info zo niet meer gevonden spijtig genoeg ben bang dat die site offline is was ook ergens op een forum ben nenieuwd naar je upload ga zo door hehehe

    • @StonedHardy040
      @StonedHardy040 Před rokem

      @@knetterman ik had dus het zelfde probleem als jij krukas. heb jij een tip waar te verkrijgen van krukasen en lagers

    • @knetterman
      @knetterman  Před rokem +1

      @@StonedHardy040 Over een paar dagen hoop ik daar een filmpie over gemaakt te hebben, ik heb wat besteld om te proberen. En zal daarbij ook aangeven welke lagers de vorige keer besteld waren en kapot zijn gelopen. Al kan ik nog niet zeggen of dat aan de lagers ligt. Krukas kan ik zo snel geen ervaringen over met je delen, heb enkel originele gebruikt tot dusver.