Kayak Cart Dolly I put together this kayak cart/kayak dolly for under $100. This was a very simple build and I believe it will get the job done! #fishing #fish #diy
If you put larger PVC pipe in your truck but just short of your easy launcher then your easy launcher can stay attached to your Hobie. My cart remains on whenever I am out of the water.
I have been wanting to build this same idea for a while. I currently place my cart in the water like it was a trailer and pull the boat up on to the bunks. I’ve always wanted to add a long handle so I could launch like a trailer on a boat but by hand.
Rather than the strapping where the tonuge connects to the shaft I would glue on a T fitting and 2 small pieces of pipe with end caps you could then drill through it and bolt it on. I thin that would be a lot more sturdy. Or, LOL you could use duct tape :-)
I’m looking for something similar for my Titan. The commercial ones are just too expensive. But I’d also like to pair it with my trailer so they can be used together.
At
Its a lot better than most of the carts they sell. Think im going too go ahead and build one something like that for my kayak
If you put larger PVC pipe in your truck but just short of your easy launcher then your easy launcher can stay attached to your Hobie. My cart remains on whenever I am out of the water.
I have been wanting to build this same idea for a while. I currently place my cart in the water like it was a trailer and pull the boat up on to the bunks. I’ve always wanted to add a long handle so I could launch like a trailer on a boat but by hand.
It’s a great idea just too bulky for me, good luck on the fine tuning and I’am sure it’s great for loading onto trailer too.
Rather than the strapping where the tonuge connects to the shaft I would glue on a T fitting and 2 small pieces of pipe with end caps you could then drill through it and bolt it on. I thin that would be a lot more sturdy. Or, LOL you could use duct tape :-)
Good job!. There are prefab alternatives, but expensive. Looks forward to your final solution.
I’m looking for something similar for my Titan. The commercial ones are just too expensive. But I’d also like to pair it with my trailer so they can be used together.
This is smart! I run a bow mount so if I make something like this I’ll definitely need to make my carry handle mounted to the bow tubes on it!
Definitely on the trail of something good. Good luck with your adjustments and fine tuning