2008 LandRover CEM All Keys Lost on bench with Autel IM608
Vložit
- čas přidán 23. 05. 2023
- If this content helped you, you can buy me a coffee or make a donation
You can also become a VIP member on Patreon to access exclusive members-only content, technical information, videos, and procedures
VIP members also unlock access to the VIP Discord chat room where users can get support from myself and a knowledgeable community
www.buymeacoffee.com/joedlock...
/ joedlocksmith
JoeDLocksmith - Automotive Locksmith and Technical Support demonstrating Automotive Key Programming Procedures
These videos are only intended for educational purpose and should not be used for any illegal activities.
UHS Hardware For Locksmith Keys and Supplies
Here's a $15 off coupon for your first order at UHS Hardware. To accept, use my referral link:
i.refs.cc/p6fUJtZs?smile_ref=...
Excellent demonstration! Very clear, concise and to the point. Bravo!!
Thanks for the video
Im afraid of bwm and audis or land roover but u make it look so easy on these cars
Great job
Nice Programming
Thanks!
Good video how do you open it i got one to do ?
Hi sir I'm locksmith in Dubai
Nice video Joe! Quick question. Do you need to remove fuses before doing this procedure or leaving fuses on is ok?
Nice video! is there a diagram of where the CEM is located on the vehicle?
I have a 2006 all keys lost can u help me plz?
I try this same mentor all the reading and writing. Dealer keys was made. But the light still blinking. What is the cost.
Привет! Решили проблему? У меня так же как и у вас мигает красная лампа иммобилайзер на приборной панели!
So is the car an HU92 blade. Also how would we verify what freq of key to use??
Looks like the one in the video is an HU101. I’m curious if the AKL procedure is the same for the Rovers with the HU92
No, if key is HU92 then the immo is easy. EWS 3 removed from console, write key using ak90 or equivalent. No eeprom dump/soldering needed.
Thank you for your video. I did follow all steps and the key was written successfully. I did put the BCM back, and the security light still flashing. I scanned and I got a DTC U0167 at the PCM that lost communication with the immobilizer unit.
What the heck is going wrong?
Any idea please?
Thank you
I have the same problem, how did you do it?
I have been fixing the same problems
@@Lasselectricalgarage привет ,как решили проблемы с мегающим иммобилайзером?
Как решили? Помогите пожалуйста
Any idea why removal of the chip? That dude is tiiiiiiny
Hi where is the CEM located on this particular vehicle?
Passenger side behind glovebox
@@JoeDLocksmith Thanks for the info!
Can’t this one be done by obd?
Spares yes.