RF Based 4 CH Wireless Remote - Working Demo

Setting up Multiple Remotes with one Rx -- One Remote with Multiple Boards
RF434 4 channel Relay board works on 433MHz frequency.Range is 100 - 150 feet even without line of sight.
You can control DC or AC loads using this board.

[@engr.ziyana.hameed1421]

Explained good, but when the jumper 1 and 2 connected it is working as touggle (touggle mean jumping from one to another) and when the jumper 3 and 4 connected it is working as Latch, so you have said as Latch for touggle and as touggle for latch. Anyways explained the practical good, All the best.

[@usrrsr]

Best ever video on such module among all rest CZcams video

[@Techybyker]

Completely agree with the other comments! Very clear explanation, it's almost a tutorial! Thank you so much sir!

[@vk4865]

Sir, very nice explaination. Speed was very correct for me.. 👍👍

[@sensordhanaraj1327]

Thank you sir for giving an excellent demo on rf module.

[@anandjoshi8554]

100-150 फ़ीट तक काम करता है ? Will it work between rooms with doors open ...about 20-30 feet ?

[@143streek]

Excellent, thank you

[@dsb4221]

Can you pair 1 button of the remote to 2 differnt relays on the same 4 ch board?

[@deepakh007]

Great thing

[@wilfredkandiero9854]

can i connect negative wire on common and positive on NO only for a DC motor

[@akantabauri1962]

Very nice sir ji thank

[@faisalsmz]

Excellent thanks, i have one without those modes , i need to have it as moment mode, can you help me

[@chennojurahuldev1756]

Can we pass the signal out(N0 pins) from the Rf receiver to arduino uno digital pins? I wanted to control your motor direction using the BTS7060 motor driver(shown in your other tutorial ). Can you please help me out. Thanks in advance

[@saifuddinsekh2077]

How to RC car control the WiFi relay module

[@athenazoey5093]

is there a chance i can combine the momentary with latch mode?

[@Praveentricks]

Yes

[@dhruvsharma8315]

How?
@@Praveentricks

[@mail2mahii]

Excellent

[@sanimotovlog5740]

Hello sir mene 4 channel kharida hai
2Channel not working
Kaise thik kare

[@kaushalchavan2515]

Can you make it on mobile operator

[@mr_pawar_3]

Can i use 9 volt

[@Avinashkumar-om1ji]

I purchased 4 chanel receiver and transmitter but after connect to load(5 volt led) that light blinks . Is there any problem in receiver. And can i convert momentary switch to toggle mode

[@Praveentricks]

From where u purchased can u provide me link

[@palanik1960]

Price and where is it available

[@joanalonsocastillo4244]

hello and how to connect in a car. thanks for your video

[@mirac.7576]

hi bro i have a project atmega16 is being used there is hex file but there is no fuse bit setting can you help me

[@futer0]

Consum batry that transmitter???