Crossfire Receiver Won't Work!!!

Your CRSF receiver won't bind? Reset it!
Notes: You may have to do these steps if you are binding to another radio OR the authentication process has been skewed on the first try. (Flashing RED light)
Local Forecast - Slower by Kevin MacLeod
Link: incompetech.fi....
License: creativecommons....
#IRONQUAD #CRSF #Crossfire #Nanorx #crossfirereceiver #crossfirerx

[@programiranje9082]

Huuuge thanks for reset option!

[@brentroberson7371]

This worked with my Tango 2! thank you so much!

[@lxcrutchy]

simple and strait forward. thanks!

[@MosOneFPV]

Thank you for this quickly fixed my issue

[@christophebunel5175]

Super merci beaucoup !!!

[@fkfontaine]

it WORKS!! 😃

[@sergioalmagre]

Thanks a lot!

[@edisonfpv5766]

nice vid bro. tnx

[@jamiefpv7576]

Thanks !!

[@888GRP]

double blinking red light never changes to flashing once i hold it mannn any ideas ?

[@IRONQUAD]

hmm, no idea but TBS support is very helpful, I would try to contac them.

[@TheMikMedia]

got the same problem with my receiver and taranis but i did the emergency reset but nothing happens. After the reset the receiver return into the binding mode. The Controller dont wanne connect

[@IRONQUAD]

1) Check your solder RX & TX (RX goes to TX & TX goes to RX)
2) To my recollection, the frsky radios need to have a mod on them for CRSF to work, please double check that
3) If you are using a quad, make sure the ports tab is active on the correct UART and the receiver protocol is correct on betaflight

[@GIaucoma]

The light blinks green and the drone beeps, I engage the binding process on my tbs tango 2, then the drone light turns red and nothing happens

[@IRONQUAD]

if you want a few seconds, your radio will ask if you would like to update the receiver. Go ahead and update it and it should be green.

[@baptistebouvat6189]

@@IRONQUAD I did that but after updating, nothing happen, the led on the rx is full green but the radio is still in in bind mode

[@IRONQUAD]

@@baptistebouvat6189 Please repeat the process until the light is red when asked to update the FW

[@HungNguyen-bk1jn]

Could you do a video connect TBS Crossfire Diversity Nano RX with speedybee f405 wing?

[@IRONQUAD]

It should be the same as this video. If you are not getting any stick movements, you may need to check the UART tab and Receiver protocol (CRSF) in the configurator.

[@GoAxaxa]

Спасибо а то я уже поза...бался

[@danitorres9626]

Could you do the same videos but with tbs tango 2 plis?

[@IRONQUAD]

reset the receiver then press and hold the "menu" button. you can access the CRSF settings from there to bind

[@glaolel3535]

Ça ne fonctionne pas je comprend pas