KRC Go Kart methanol engine start-up(2018) On B&S Animal Engine
Vložit
- čas přidán 7. 09. 2024
- KRC Go Kart Methanol engine start-up.This video will help you start your Animal karting engine after a long break from racing. You need to have a tillison pop off tool to get your carb to pop off at about 8#. Mel also shows how to prime the fuel pump to revive it with wd-40. Stay tuned for other tips and products from KRC Racing. Products proudly made in the USA! 800-814-5745 Please comment on how you start up!
![LO206 vs Briggs Animal Engines Pt. 1: A Guide to Clearing Up the Confusion. [TheQuickLO206 - Ep. 3]](http://i.ytimg.com/vi/uh5UqOFOwwM/mqdefault.jpg)
![LO206 vs Briggs Animal Engines Pt. 1: A Guide to Clearing Up the Confusion. [TheQuickLO206 - Ep. 3]](/img/tr.png)
I used to run open modified blockzilla's using the Tillotson carbs and running methanol, we figured out after the race run about 8oz of unleaded gas ran through cleans out the resedue methanol leaves during the week. We were always proactive and getting prepared for the next race the day after we we finished the race.
Just trying to help.
What style of tillotson did you use?
Watch out for WD-40. Don't use it. It is not meant for aluminum engine parts of any kind. It causes big problems over time. WD-40 is a penetrating oil its an industrial strength penetrating oil. Your better off with a silicone spray or CRC or simple oil. WD can destroy motors and chains and bearings. It is meant to loosen rusted stuck on nuts and bolts and is abrasive if run in motors on chains and bearings, do not use. 5 to 20 weight oils are a better choice. This is from 30 years experience where I couldn't figure out why all above were failing all the time. I finally dropped WD and all the stuff had no more problems. WD is thee best when used for what is made for and, however , can't fault them there, reliable.
I love to have one of those carbs for my built Honda 2stroke scooter it’s been bored and stroked. Very nice
How does it run?? I have an elite myself
It runs well. Thing is when you’re bore an stroke them. The compression goes up, so the starter needs to be changed for one that has torque to start. There is a definite difference between the stock stroke of the crank and the one I have in it now.
FrankiE Rutherford I see what crank are you using?
Phongeer crack. Scooterswapshop.com sells them.
Sounds great..love to get predator sounding like this
You can with enough money
Sounds Awesome! Very responsive!🤔😎👍
i have the same engine and carb. how the hell do i hook up the throttle cable.
What size and style of tillotson carb is this
Hello from Germany. I hope you understand my question. How do I put the crankshaft and camshaft correctly into the engine. Sorry, I couldn't find any Marks. Thx a lot!
What is done to the engine I'm thinking about buying a animal and building it upvi have a gx200 putting out 20+hp
Fuckin thing sounds amazing
have you messure sprak plugs heads cap at what its optimal in that engine becauce back in day i use cap 0,6mm in 100cc engine and its was optimal in that engine and i use 102 octain fuel
Hi Mel, what’s the exact HP out of the box for a Briggs and Stratton animal?
How fast does a kart like this go?
Not fast , rotax, rock and iame are faster, i'd go iame if i were you
@@samurboi8007 Depends where you're starting, Rotax is best for beginners, Rok and Iame are for more experienced drivers.
Is this 18 HP from 7hp stock?
I believe there like 8-9 hp stock.
Is that a bandit
What brand/style header
How do you get the engine to idle without wanting to push the go-kart on its own
i think he has Centrifugal switch attached to shaft, for example when rpm is higher than 2000 it will spin
@@paavo1294 certainly.
other use of methanol is its low level of pollution in the racetrack.
I luv my honda,Honda, over animals,got hp out of honda,2 bad suckers,suckered, it over again ,guys u missed sum,th,n ha ha!!!