ProTaper Handlebar Install - KLX110 Bend | 2023 Honda Grom Build Part 8
Vložit
- čas přidán 25. 03. 2023
- Finally swapping the bars on the 2023 Honda Grom ABS after having the parts in hand since the first part order. This was a little involved, but not terrible!
The (improved) STL for my little vice holder is located here:
www.thingiverse.com/thing:593...
Link to the bars on Amazon:
amzn.to/3IXu4c2
Link to the throttle tube on MNNTHBX:
mnnthbx.com/product/mnnthbx-q...
Link to the Motion Pro Road Control grips:
amzn.to/3N7Jrkt
And shoutout to @TheGardenSnake for the pro-tip on the tape trick
(Note: As an Amazon associate I may earn on qualifying purchases at the above links) - Auta a dopravní prostředky
I had to subscribe. I have a Navi & 2022 Grom. 😎
Haha hell yeah! What colors? Any good mods I haven't done yet you'd recommend?
@@SpencerDesmarais Blue Abs grom, and I also have SP plastics that I removed the decals from. The Navi is Grasshopper green, but I have Hunter green plastics to paint soon
@@thuggyduggy1525 The blue with the white washers is a great color, nice. They had one on the floor when I bought mine and I was tempted! I couldn't resist the gold wheels and forks though haha
CT 90 ? Hell yes.
Well hell yes, then haha. 1967 CT90 with a YX140 engine swap, CB125 front end, and a good deal more customization all around. Put an oil cooler on it this summer and it started spewing oil through every seam in the cooler and it's been sitting ever since.
I put the protaper honda mini se and love them on my 22 grom
Is that a higher or lower bend than the KLX? I can't remember
@Spencer Desmarais it's lower than the klx I'm 6' and fits me perfectly
@@jk33006 Nice, I bet that looks good! Even the little bit lower than stock that the KLX is makes an aggressive difference in the look, I bet the lower bend on the mini takes it even further.
I also did Honda Mini on my 19 Grom. A little lower and just a little wider then stock, didn’t cut anything, all cables and connections reach no problems no modifications require
love the look of Honda mini
3D Printing seems to be super valuable with this build, that’s for sure ! Are you going bar end mirrors ? Or sticking with the stock mirrors ?
instead removing the throttle cable why didnt you just remove the handlebar clamp and then pull the bar to the side to slide your throttle tube out easily way easier
Dude overthinking everything yikes thought my ocd was bad wasting time unhooking things didn't need too, printing stuff a hose clamp could take care of and lubing drill bits on aluminum this is comical. Maybe if you wanna do indept videos explain the 3d printing. These are bikes not scientific instruments of speed ... nice approach though just seems like a lot of wasted energy and time .. like this comment 👌 😅
My ocd killed me reading this comment.. @anthonymoy4471