How To Disassemble & Assemble BOSCH - Switch Button & Control Problems - BGL6HYG1 Vacuum Cleaner
Vložit
- čas přidán 13. 09. 2024
- How to disassemble & assemble BOSCH vacuum cleaner parts (switch button cover, remote control sensor, top cover, bag cover). Video guide for motor & cord winder replacement or any repair purposes.
Model: BGL6HYG1/01
www.proexservi...
www.proex.sk/
2:56 Power button cable has a connector which does come off from PCB just by pushing with a screwdriver. And then you can see and get access to the plastic latch which holds the power button.
Hello, is this common probeln on the series 6. Is it maybe better to buy serie 4, like bgls4pow2 instead of this?
Hello, no, it is not common problem, just dont step on plastic on/off button and it will be fine for years. 👌
@@proexservis thanks for reply. Just one more please, which model would you choose, this one or bgls4pow2. Actually, i prefer more bgls4pow2 because it doesnt have that remote power on the handle but i really want to know your opinion. Thanks
@@kostobiocanin1556 i would choose without control handle too, control handle vacuums are more expensive and one more problem if it get damaged.
@@proexservis thank you once again for reply. You just verified everything that i suspected about difference over those two models.
Hi, how to disconnect IR? I try do it from the inne side but I'm affraid that I will break the cable. I can't take the llastic button which helds the IR sensor
Hi, you have only 2 options, 1: pry out plastic cover (button) and disconnect IR or 2: pull up whole rear cover with circuit board like I did it.
Any cable can be repaired, dont be afraid to pull it little harder 👍
I got it! :) thank you!
mine does not stay on when pushed was it the same problem?
@@tonypasma1707 probably you have bad, faulty on/off button (switch)
@@proexservis how do i take out the plastic button