AIR QUALITY SENSOR ON VOLKSWAGEN , SKODA AND AUDI | REPLACEMENT | OBDELEVEN
Vložit
- čas přidán 21. 11. 2023
- In this video we replaced the air quality sensor on a skoda superb 3v , the process is going to be the same for almost all the audi , skoda and volkswagen cars which are equipped with an air quality sensor . as it was showing a fault code on obdeleven as a faulty sensor . Quite a common problem due to dust and other environmental factors .
part no. - 500 907643B
tools required - absolutely nothing - Auta a dopravní prostředky
Clean the sensor with contact spray and with a blower to dry, it will work, no need to spend money yet. Mine still works ;)
Sir, I have vw polo 2014 mpi, it’s radiator fan makes lot of noise. I have shown it to multiple technicians but everyone is saying it’s common to get this noise. Is there any solution to it. It’s not driven a lot, just 25k. Any suggestions?
[27/11, 19:22] Jitendra Mishra: Subject :- Regarding my Car Vento TSI still not running.
The point wise details under the above topic are as follows-
1. I have Volkswagen's Vento 1.2 TSI petrol car, which has DSG Gear box. This is a 2017 model and has covered only 26000 kms so far.
2. Was parked in the parking lot last July 2023. The entire tire was submerged in the flood water and the inside of the car was also filled with water.
3. Due to this the gear lever was not shifting from P mode. P was flashing in the dashboard.
4. The car kept drying in the sun for 15 to 20 days.
5. Even car was starting well. The original sound was coming like a new car. Engine was perfect.
6. After watching a video on CZcams - "Factory reset DSG gear box in minutes", I did the following while standing -
(a) Sitting inside the car.
(b) Locked the doors.
(c) Put the key in the ignition and turn it to accessory position. Waited for 15 seconds.
(d) Now pressed the gas pedal and kept it pressed for 30 seconds.
(e) After this, switched it off and took out the key.
(f) Took the foot off the gas pedal.
(g) Now waited for 3 minutes.
(h) After this the car was started.
7. After doing the above steps and starting the car, a loud noise came from below. The engine sound started getting louder and the RPM also increased slightly.
8. After this another incident happened. To take the car to the Service Centre, open the cover of the gear lever, press the yellow button and put it in Neutral in the Emergency programme.
9. During this emergency program, the lever shifted to Reverse (R) due to which the whole car shocked and there was a loud rattling sound came from below.
10. In the company's Bhopal service center, the entire system below gear lever was only found to be damaged due to waterlogging, which was replaced with a brand new one.
[27/11, 19:36] Jitendra Mishra: 11. Service center people said that flywheel and clutch plate will also be changed but I
Refused because the car had driven only 26000 KM. The center wanted to increase the estimate. I felt that way.
12. After having cleaned the rust/dust and clean the fly wheel with chemicals, gear box fitted back.
13. Brought home 300 KM from Bhopal while driving the car. On the front left side of the car, intermittent gurgling sounds and shocks kept coming.
14. Now there are vibrations in the engine when the car is started. The sound is also getting louder. Although RPM is normal.
15. When driving on the road, intermittent whirring sounds start coming from the front left side and jerks are felt intermittently. Gears fit properly and do not slip.
Please tell what could be wrong with the car? What should I do now? I have already spent Rs 1,50,000 in VW service center but the situation is same. Car is not able to move on the road.
Jitendra Mishra from India +91-9926518790 Vehicle No. MP-04 CU0868
I have Storme 2015 88k driven .... Usme cold weather m temperatures neeche jaata rehta h.. Mne OEM thermostat valve lgwa liya...
Agr truck walo ki trah radiator ki front air blocked kr deta hu toa sab OK rehta h
1 - agr temperature sensor error hota toa heater kaam krta... Plz help me 🙏
Hi bro. I have a 1.5 tdi MT. I replaced the injectors and pump, also common rail. When the engine is running with AC off there is knocking. When the AC is ON there is no knocking. Any sensors or things i need to check? Im not sure about sensors as no fault codes came on OBD. But i check the injectors fuel flow and other parameters, all in limits. Also checked the same injector set in other car. No injector knocking.
Major issue: knocking when AC is off, car feels super smooth with AC on and no knocking.
Help pls
Sir , replied to you on mail .
Hi, I’ve got a Skoda kushaq, there is a clunk noise when pressing the clutch in very slow speeds and in 1st gear - it can be reduced by having a small amount of gas when pressing the clutch
It’s even more consistent if going uphill and pressing the clutch to roll to a stop
Is there a problem and what might be the cause of it
Maybe the pendulum mount is not holding the drivetrain lash-back
Hi, your CZcams DIY videos has helped me a lot and im grateful for it Bro.
I was checking for a vw 505.01 approved oil and found MANNOL 7913 Energy Formula PD SAE 5W-40 in Amazon which cost only 4k for a 5 liter can. But on the bottle it says HC Synthese which makes be doubt if its a fully synthetic oil. Can you please help me out. I have a 1.2 tdi polo
Go ahead , buy it , it has the approval and its quite cheap as well now , last time i checked it , it was 7999
Thanks for posting. I have a Skoda Rapid 1.0 and there is a constant tik tik noise coming when in recirculation mode. What could be the issue ? There are no fault codes.
Faulty flap control motor. They are known to go bad in vw cars
Yes thats right
@@yourDIYneeds Thanks @tanvirsinghkohan6815 . Can we change it by DIY method ?
I am always dreaded when visiting Skoda ASC. 😢
It can be done , its easy
@@yourDIYneeds Thank you very much. Any idea where I can procure this flap control motor ?
Hi sir I have a 2014 rapid 1.6 tdi the car is making some weird noise when releasing the clutch like metal sound and I have to keep pressing the accelerator the car doesn’t glide by it’s own and keeps showing me to downshift the car from 3rd gear to 2nd even in 40 kmph what would be the issue ??
How much is it driven ?
83k
Sir , does it skip or slip when you try to accelerate hardly on 1st gear ?
@@yourDIYneeds no it doesn’t but there is metal like sound when I leave the clutch little faster
@jatinpawar2027 does it feels like its revving more and accelerating less ,
Bhaiya honda city mai cng lagana tik raheyga ya nahe....please bataye cng se koi problem to nahe hoti?
Short term koi problem nahi hai , but long term definately effect hoga
@@yourDIYneeds thanks brother
hello sir
i have another issue on my VW polo 1.5 TDI because of very poor VW service.
I went to VW for control arm change , brake fluid bleeding , brake disk resurfacing and brake pad change.
After coming home i have issue when i turn my steering fully there is heavy humming noise and on road at speed above 80 when i press brakes lighly steering vibrates. when clutch is not pressed it produces light vibration and when clutch is pressed it feels like whole car is shuddering while braking
While moving or stationary?
@@yourDIYneeds hello sir
rubbing sound and hinderance to motion is only oberved when steering is fully turned and movement started
steering vibration and slight forward back movement is observed when light brakes are applied in 90to100km/hr
all this started happening when VW service center changed brakepads and control arms then brakebleed and machined rotors
Check the electrical continuity of the system
Hello bro which engine oil is best for Mahindra xuv500
It's 2.2 liter mhawk diesal engine 140 hp
Sir , always follow the recommendation of manufacturers for oil grades , thats the best
Which is good Castrol edge, Castrol magnetic suv or gulf
Sar aapki Tata Safari kider hai
Maybe you could share your source for parts and we also get the benefits.
Sir anytime you need it , just mail me on everydaydiyhelp@gmail.com i will give you the contact details of the person
I want to purchase obd eleven device but payment through sites given by you not becoming success. So what can we do?
I can order for you , at your address , just did it for someone In gujrat.
Will a faulty one affect ac cooling?
Not directly but it will keep the recirculation valve open for outside air , which can effect the cooling or heating indirectly
Ok thanks mine keeps showing faulty in scans and then goes away on its own. Happened once.Think maybe water ingress after car wash
@tanvirsinghkohar6815 yes sir , it can be
I have problems in vw jetta car me Subha start nahi ho rahi h jyada self lagane par oil pressure light a rahi h kya kar na chaiye or oil bhi gada ho raha h
Diesel or petrol
Diesel
Why not attempt to at least test the Sensor, then clean it with Mass Flow Cleaner (fastest evaporating) and then test it again?
I just fixed my Fuel Cap Activator by WD40 and ratting it along with repeating LOCK button on FOB. Things get blocked up with dirt and need cleaned.
Sir that can't be done in case of air quality sensor , as the dust or gunk dissolved by mass air flow cleaner will settle on the membrane and temper the data of the sensor .
@@yourDIYneeds ah ok thanks
Hello bhaiyaa
Hello
Hello sir
Hello
Bro how can i contact you ? i need to buy obd eleven but due to problems i cannot place an order....please tell me your insta or contact number...