LS EFI TANK MOD (AN -08 FITTINGS) ON THE PRO TOURING CHEVELLE

I SET UP EFI TANK TO RUN AN-08 FITTING FOR THE LS SWAPED CHEVELLE WITH A TANKS INC HELL CAT FUEL PUMP.
www.tanksinc.com/index.cfm/pa...

[@WhyZeeMx]

Just went to install the the fuel pump on my gbody tanksinc and ran into the same fitting issue lol glad i'm not the only one

[@chui19801]

Goosse. I am watching your video because I am bored. Just got home from work. I have to say. You are funny as hell. Some of the mistakes you make might or might not be on purpouse but damm kiddo. Dammmmmm Gina. Dont rush your work. I have the same set up on my 66 and the only thing I had to add later was the roll over valve. I just have to say again. Dammmm Gina.

[@cfmechanic]

Do you get fuel slosh issues with this tank. I got same one but at half tank or less it will slosh on launches hills and turns

[@goosseperformance1444]

No issues with that

[@skitv8780]

where did you buy the access door? Great video!

[@goosseperformance1444]

Link in description below

[@edward71ful]

I used the same thread sealant and it leaked. Third time I dropped the tank i used Teflon tape, no leaks 4 years later.

[@goosseperformance1444]

I have ran in to that but but it also could be a bad fitting have had to change the fitting out a few times

[@edward71ful]

@@goosseperformance1444 Very nice build btw

[@chui19801]

Now that I have finished your video, I will say that you are fired. That grinding was not acceptable. What I did was, I got some brass fitting nipples about 3 inches long with a female end for the 6AN. That way if I have to loose those babies, I can do it from the bottom of the car. I wish I can send you a pic. You are still fired. LOL