How to Replace Door Jamb Switch 2002-2005 Ford Explorer
Vložit
- čas přidán 25. 08. 2024
- Buy Now!
New Door Jamb Switch from 1AAuto.com 1aau.to/ia/MCZM...
This video shows you how to install a door jamb switch on your 2002-2005 Ford Explorer. The door jamb switch monitors the opening and closing of the door, and alerts you via an in-dash warning light if your door is not properly closed. It also controls the function of your overhead lights when the door is open.
This process should be similar on the following vehicles:
2002 Ford Explorer
2003 Ford Explorer
2004 Ford Explorer
2005 Ford Explorer
Tools you will need:
• Pocket Screwdriver
• 5.5mm Socket
• Trim Tool Set 1aau.to/oa/1AXX...
• Pliers
• T27 Torx Socket
Subscribe: / @trq
Check out our playlist:
Ford Explorer 2002-2005 3rd Generation: • Ford Explorer 2002-200...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Great video. For anyone doing this, you may want to also buy a lock to have on hand. The sensor pin is held in place by a plastic retainer integrated into the lock. Rotating to remove may destroy the plastic so that you cannot get the new sensor to stay secure. I wound up replacing both the lock and the sensor because of this issue (plastic retainer shattered when rotating the sensor for removal). Note that the actuator separates from the lock by pressing a black tab. Look for videos on it as it isn't intuitive. Also, the locks are sold bare so you will need to transfer all of the plastic clips and bushings from the old lock if you are unlucky and damage it.
Thank you for a video that FULLY stated and demonstrated the steps without unneeded hyperbole. Now I'm off to throw more parts at the problem because that's how this truck is for me lol.
+Craig Campbell Thanks for watching our video! 1aau.to/m/Shop-TRQ
Having the same problem right now, and I have to go fully at it. Thank you so much for your video. Very helpful.
This fella makes a good video. Very thorough.
Thank you Thank you Thank you. This was a very helpful and informative video.
Thank you! Will use this while working on my 98’ Expedition switch. Some light stays on. Driver side passenger door switch needs replaced.
The part at 5:16 where the door lock rod is disconnected is missing. You can see it sitting above a certain hole when you inspect the window channel, next thing you know there's a camera cut, and then its well below that hole, disconnected. Whoops.
Would this be the same for an 06 expedition? Nobody at all shows how to stop the annoying dinging
Hi. Would you happen to remember the color of the wires for the door switch sensor? They look like yellow and black. I know i can be wrong. I have an 02 Ford Explorer XLT 4.0. TIA
not the same as a ford sport trac explorer