Extrusion Blow Molding - Lesson 7 - Parison Programming

This is an excerpt from Lesson #7 in Paulson Training's Extrusion Blow Molding Technology training program. This lesson is titled "Blow Molding Parison Programming".
More Paulson training videos are available for viewing at the Plastics Training Center. You can sign-up here for free access: plasticstrainingcenter.com/inj...
Information on the complete Extrusion Blow Molding Technology training program can be found at:
www.paulsontraining.com/produc...
If you would like to see a demonstration of all of the video lessons in this course, visit our website and submit our Request Info form:
www.paulsontraining.com/get-st...
Train production personnel, supervisors and managers to understand the basics of extrusion blow molding technology, plastic behavior during the blow molding process, machine set-up for optimal production runs and common problem solving situations. The course will prepare your blow molding personnel to:
1. Develop a working knowledge of blow molding machinery
2. Evaluate and improve operating procedures
3. Recognize processing conditions that affect quality
4. Analyze and solve practical blow molding problems
Lesson 1 - The Process and the Equipment
Lesson 2 - Plastic Behavior
Lesson 3 - Extrusion Blow Molding Operating Controls
Lesson 4 - Operating Procedures - Start-up, Operation, and Shutdown
Lesson 5 - Part Quality and Problem Solving - Part 1
Lesson 6 - Part Quality and Problem Solving - Part 2
Lesson 7 - Parison Programming

[@florbibiano]

Thank you for your videos. Helping me to better understand the plastics process.

[@Nassimatepropack213]

thank you for your videos, it's really helping me to better understand the plastics process and troubleshooting, thank you again and always

[@jinjun-blowmoldingmachiner1835]

Oh, Moog, this is the best lession i had seen about the parison thickness controller.

[@umeshp2002]

Sir, i need to know more about parison programming. Will u plz make a few more videos on this

[@timpono]

My parison (one of two) suddenly turns ALOT to one side. Also it becomes 2cm longer. Then after a while it goes back. Please if u got any tips throw em here !

[@sureshnair8658]

thank you

[@globalindoabadi7954]

thanks your informs

[@parisonravalomanda7670]

Got the same name. Thanks for the lesson :)

[@gregdarrelpeque4641]

hi

[@santoshlokhande3246]

How to solve the pinch of problems (parting line shift)

[@acepsaepuloh6835]

I'm sorry Sir, I have a question,
How to calculate the diameter of die and pin?

[@shridharn2002]

Use the Formula for Calculating Die Pin Diameter
D=Wx2/π
Where,
D=Die Pin diameter
W=Width of Cavity
π=3.142

[@vaibhavtelange9114]

👍👍👍👍👍👍

[@brandonmiles8174]

Hey, look, that's the WTC screen I use every day. Well, hopefully not every day.

[@ankitjain8127]

this is the "chodampatti"..

[@dhanusingh3730]

I arbind Pathak from cipet Hajipur nice but not satisfactory