Installing and wiring a new Battery charger for the TC Wanderer

I ugraded my 4A Super Soco TC Wanderer charger to a 10A charger. This requires a plug and soldering. Very easy to do if you follow my instructions. The power supply is very good quality and delivery was very fast (Less than a week). Different current sizes are available up to 15A this works on the TS Street Hunter as well.
71.4V 10A Li-ion Battery Charger aliexpi.com/RfTw
Super Soco Charger plug aliexpi.com/IgI7
XT 60 connectors (3 male 3 female) aliexpi.com/GVPQ
4AのスーパーソコTCワンダラー充電器を10A充電器にアップグレードした。これにはプラグとハンダ付けが必要だ。私の指示に従えば、とても簡単にできました。電源はとても品質が良く、配送もとても早かったです（1週間以内）。TSストリートハンターでも使用できます。

[@Med-Amine]

Thanks for sharing ! I was waiting for this video ! So the connector is the TC/TS round pin plug ! I wasn’t sure about that as it has less small pins, but as you clarified very well, these are not needed for the charge except the one that goes with the negative.
Thanks again

[@DistantSuns]

No problem, glad to help.

[@tjagarin]

4A charger all this time,respect. My 10A is slow(7h for 2 batterys). Great job as always.

[@DistantSuns]

Thanks, Now I’ve got the new charger I regret not doing it sooner 🙂

[@HubbHubbs]

Hi, I would always ensure you plug the mains into the charger before connecting the DC to the battery, otherwise you get a large current draw from the battery back into the charger to fill the output smoothing capacitors which can blow a fuse or even trip the bms if your batt is very low.

[@DistantSuns]

Understood, thank you for the advice and thanks for watching.

[@trufinv]

Thank you for sharing this pinout. Can I ask where you sourced it? As I have a Street Hunter Pro that I will need to work on and I was under the impression that it uses CAN instead of rs485 for communication. Thank you.

[@DistantSuns]

No Problem, I made the printout myself. The wiring harness under the seat has labels for each of the wires. The communications labels have 485A and 485B printed on them.
Thanks for watching my videos