Great video. This job would be difficult then without a lift? i have groan/whine noise goin through the gears around 2000rpm. More prominant in 1st/2nd/3rd. No sound when not in gear. Is is a bearing starting to go inside the gearbox? cheers j
It’s possible without a lift, but hard on your body. I’ve done it on axel stands outside 👍 Just make sure you get it up high enough. I had two wheels stacked on top of each other, flat on the ground next to the axel stands in the front for redundancy/extra safety. And back of the vehicle on small ramps.
Great video I watched it to do mine ,2015 5 speed . Can I ask advice ? I've reaplced ut as I had a weird sound when I'm going slow I can hear when I dip cluch I get a rumble noise thought duall mass ,it's still doing it ? Any odea please 50k miles ,wheel bearings ? Gearbox thank you graham
If the sound changes when you steer left and right it will be a wheel bearing, jack the front up and spin a wheel by hand and put your hand on the track rod end, any rough feeling it’s that side
Scotty lad. Crackin video. A question regarding the oil leak on this van, did you find the source? Doing me gearbox and have the exact same oil residue!! Haha! Thought you may know where to start looking. Cheers.
At least ye don’t need to drain the gear oil on these
You just saved me so much fucking time for my tomorow job mate exellent video and amazing explanation thank you so much mate
Great video. This job would be difficult then without a lift? i have groan/whine noise goin through the gears around 2000rpm. More prominant in 1st/2nd/3rd. No sound when not in gear. Is is a bearing starting to go inside the gearbox? cheers j
Hi and thank you, yes sounds like a bearing
It’s possible without a lift, but hard on your body. I’ve done it on axel stands outside 👍 Just make sure you get it up high enough. I had two wheels stacked on top of each other, flat on the ground next to the axel stands in the front for redundancy/extra safety. And back of the vehicle on small ramps.
Great video I watched it to do mine ,2015 5 speed .
Can I ask advice ? I've reaplced ut as I had a weird sound when I'm going slow I can hear when I dip cluch I get a rumble noise thought duall mass ,it's still doing it ? Any odea please 50k miles ,wheel bearings ? Gearbox thank you graham
If the sound changes when you steer left and right it will be a wheel bearing, jack the front up and spin a wheel by hand and put your hand on the track rod end, any rough feeling it’s that side
Scotty lad. Crackin video. A question regarding the oil leak on this van, did you find the source? Doing me gearbox and have the exact same oil residue!! Haha! Thought you may know where to start looking. Cheers.
Give it a clean and check for leaks when it’s running