DIY Drones - CC3D based drone(Part 3)

#CC3D #ATL #Projects #Drone #DroneProject #DIYDrone
In the Third & final part of our drone Video, we have shown how to connect, upgrade the firmware of CC3D, Calibration of the Motors & pairing of the Remote
Link for the Software - librepilot.atlassian.net/wiki...
Name of Flight Controller - CC3D
Name of Remote - Flysky FS-i6
Tools used - 2.5 mm Allen key, Soldering Iron, Cutter, USB to mini Cable & Stripper
Link for Our Channel -
/ @robokidz_yeg
Subscribe to our Channel for latest content on Robotics, programming & electronics

[@user-kn6ni9sg6k]

there is not the old working version file ?

[@ShibsankarBiswas-le9ou]

❤

[@chaoticlabzdev]

Hey i am having some problems, when i increase the throttle and then lower it back to lowest level the motors still keep running even after disarming the drone

[@atilganiha4733]

can you add the .bin file to comments please?

[@mahrubaimam5942]

Sirr I have a question the output of my cc3d board which connect to the reviver has no positive and negative plug as it's consist of singular wire output what should I do.

[@robokidz_YEG]

Not all the input connectors of cc3d has all 3 pins. Only one connector will posses the power supply pns for the unit the rest are just the signal pin for respective channels. I hope this has clear your doubt

[@yanthuk-channels]

Boos, I use librepilot, I can't connect via USB laptop, how can I connect, are there any additional files,

[@robokidz_YEG]

In that case u need to flash your cc3d controller using cleanflight.
Check the video link below for reference
czcams.com/video/DRm_CyAyKcs/video.html

[@FenoRandr-di2hi]

hey, can you send me .bin file?

[@Xavierfun12345]

Sir ... I can't save the program 😭