What a clifhanger. Spot could not be any tighter. Wiev is completely obstructed and with those cutters one does not know if the new thread is any good until you take the cartridge off the pipe. Luckily Hardie knows whats up! Also glad to see that HF cutter actually does the job. Always looked at it in the store and wondered. Thanks for sharing. 👊💪
Your right about the tight spot. I wish I would of recorded the next one I did. I only had room to back up with channel locks... That one I would take some material off and then reverse it until clean amd repeat. Could not risk distorting the end of pipe.
What a clifhanger. Spot could not be any tighter. Wiev is completely obstructed and with those cutters one does not know if the new thread is any good until you take the cartridge off the pipe. Luckily Hardie knows whats up! Also glad to see that HF cutter actually does the job. Always looked at it in the store and wondered. Thanks for sharing. 👊💪
Your right about the tight spot. I wish I would of recorded the next one I did. I only had room to back up with channel locks... That one I would take some material off and then reverse it until clean amd repeat. Could not risk distorting the end of pipe.