Battery restoration| rebuild NI-CD to li-ion for makita impact wrench old version

In this video I will restore and replace nicd to Li-ion battery with BMS for old model Makita impact wrench
I hope you find this video useful and enjoy!
I’m happy to receive your feedback.
Thank you very much for your likes and your comments
#repair_and_restoration
#nicd_to_liion
#battery_replacement
#repair
#restoration
#rebuild_battery

[@m.nooria.8957]

Goed gedaan 👏👏👏

[@jonhamilton8247]

Nothing like a good :calibrated impact adjustment :

[@arenasinda_kor_savasci]

Merhabalar bms devre şemasını paylaşırmisiniz

[@robinmidgett3347]

Please list the sources for the LiOn batteries and the BMS. Are these 18650 batteries you chose?

[@manofallseasons8752]

Nice Job!!!

[@paulmichaelfreedman8334]

The only problem I have with this video is the use of an impact wrench to tighten vehicle bolts which always have specific torque specs..😵‍💫 You're asking for a mid-journey freak accident.

[@metroh6094]

Very good 👍😊هاذا لي اريده

[@alexandres8846]

To balance nimh battery packs, a circuit with two 1n4007 diodes in series plus a resistance of 1 to 10 ohms is used.The voltage drop in each diode is 0.7 volt x 2 is 1.4 volts.The resistance limits the intensity of the balancing current. Being soldered to all Ni cells this increases the life and performance of the battery pack.

[@repairandrestoration4238]

Thank for your infomation!❤️❤️❤️❤️

[@khosrowbahari4064]

Hi sir
Do you mean lituum batteri or nickel cadmium batteri? because in this video the guye rebuild nickel cadmium batteri to litium batteri.

[@atdforgebc4605]

May i ask why did you choose 4cell instead of 3 cells?. Is it ok to far exceed the voltage? Do these motors from power tools can handle higher voltages., if so by how much? Thank you

[@alanerickson3075]

I am currently running a whole lot of older Makita and Hitachi 14.4 volt power tools on Milwaukee M18 batteries. First I made some adaptors to fit the M18's out of 4mm acrylic then I epoxied them to the top halves of the dead 14.4 NIMH battery cases and they slid right in. Other than having to put a screw in the old battery cases to hold them into the tools they work slick as owl shit. Also I've been using them set up like this for 7 or 8 years now with no problems whatsoever. I chose to use the M18's because I also have a lot of Milwaukee tools and you cant over discharge them as soon as they get below 18 volts they shut themselves off.

[@repairandrestoration4238]

Thank you very much for your like, and subscription

[@normandothegreat]

I have the 14.4 Makita set still like new, but the batteries are garbage. I wish you sold the upgraded kits.