Peugeot 208 1.2 Petrol 2016 Wet Belt Change Part 2 I Tried To Repair The Exhaust But Made It Worse ?
Vložit
- čas přidán 21. 08. 2024
- Hello and welcome
This episode on the Peugeot 208 1.2 Petrol 2016 Wet Belt Change Part 2 I Tried To Repair The Exhaust But Made It Worse ?????
Fix the hole with exhaust patch tape and exhaust pipe clamp. Then drill a hole for a stainless bolt and nut in both the two side brackets. Then run around a stainless cv boot "tie clamp" and tighten it with the special CV boot pliers.
21:45 Why don't you buy nut extractor, did my astra with these after getting rid of the ring . Brilliant tools.Also better than destroying sockets and replace them with standard nuts who nicks alloy's nowadays 👍
Hello Mark,great video the car sounds good not what you want on the exhaust but you don't think it would happen.have a nice weekend.
@@stevenjones19-m8i thanks mate have a great weekend 👍👍
Just a thought, a cheap flux core mig welder is a good choice for thin metal. Less likely to blow holes and fairly easy to patch them if you do. I have done a lot of successful exhaust related repairs with mine and I'm not a welder at all, just watched a few CZcams videos.
Hi Mark. You sounded Exhausted after that. 😊 Problems are put in our way now and again. To be overcome or, remember never do that again. See you in the next one. Cheers.
@@normanstephens5391 thanks mate it was exhausted a nice weekend off 😓👍👍
just catching up with your vids after my jollys had the same problem with my exhaust its a comon problem got my mine fixed by the local exhaust doctor just taced a plate to it but there is an after market bracket you can buy its a u clamp with bracket attached for rubber mount to fix to
Arc welding is quite hard, mig is much easier
Yet another constructive day at resurwreck top job thanks for sharing have a top weekend 👍👍
Would still have done water pump Mark may come back and bite you on the but!😂😂😂😂😂 ps have a nice weekend mate !
After doing all the belts on this vehicle l would replace the exhaust would look better for future customers so bite the bullet and replace try your scrap yard contacts first or eBay good luck enjoy the wend
i think a plate would have been a better repair on the exhaust.
Need a mig welder as the arch welder will burn though
Hi mark have you watched Car uk he reviewed this car 🙈
@@billhaughton6431 hi mate no I haven’t I’ll give it a watch 👍👍
Hi Mark no big deal mate you learn by mistake