Celtic Timber Oak Beam Mantle Installation Video
Vložit
- čas přidán 13. 02. 2020
- How to install an oak beam mantelpiece using straight brackets.
IMPORTANT - 12mm timber drill bit, not 13mm as mentioned in the video
Buy your oak beam here - www.celtictimber.co.uk/produc... - Jak na to + styl
how thick was that beam please?
Our brickwork chimney breast is finished with dot and dab plasterboard, do these fixings have enough length to pass through the dot and dab safely?
How did you get on on J G?
Haven't got round to it yet, would prob just need to make sure fixings are long enough
Where can you buy fixings for oak mantle.
Hello. We sell them on our website - www.celtictimber.co.uk/product/straight-brackets/
Didn’t get the name of these brackets didn’t understand what they are called do you have to buy 10mm wall plugs thanks ps my beam is 90mm deep should I order the 55mm or the 80mm
Hi Paul, they are straight brackets and come with wall plugs. I would advise 80mm if you are confident enough to drill that deep without going through. You can use tape as a marker. Brackets are here - www.celtictimber.co.uk/product/straight-brackets/
Hi, what’s the max weight a beam can be? I’ve just picked up a piece of reclaimed wood that’s 51” long and it’s quite weighty..
Hi, do you know how much that beam weighs? We use these for some very heavy oak beams and recommend one bracket per foot - but you could use more if you are concerned.
Hello Celtic
Just about to order a beam but the chimney breast is covered in plasterboard. Does this actually work over plasterboard? Also would I need adhesive to keep it there initially?
Many thanks
Hi
In the case of plasterboard, you can fix the beam to strong points in the framework, but it is probably best to consult a local carpenter etc. If you let us know what cross-section and length you are looking for, we can let you know an approximate weight for the beam.
Thanks
Celtic Timber
Should you need to is it possible to remove the beam without damaging it or the wall?
Hello. With the right tools yes. But if the beam had been in place for a while, it would have naturally moved and tightened around the brackets, making this more difficult.
Is it a 10mm wood bit you use for drilling wooden beam
Hi Paul, it is 12mm for drill into the beam and 10mm for the masonry/studwork.
Could the end of fixings be reduced with a grinder by 10mm the beam I’m going to use is 90mm and the fixings are 80 mm so not much room for a mistake
@@paulweller918 yes, absolutely. Or a hack saw if required.
Helpful video, but you should really add a text overlay on video or re-record it as I bought a 13mm drill bit and drilled one hole in my beam
Apologies Brad. We are unable to edit a video once it has been uploaded to CZcams. We have placed that information in the video description and in a card that appears when we mention 13mm in the video.
What kind of brackets did you use?
Hi, for most size beams, we use straight brackets - www.celtictimber.co.uk/product/straight-brackets/.
For thinner sizes, we provide keyhole brackets instead
Thanks
Celtic Timber
What's stopping it falling off?
A number of factors - the brackets have grips on them, and they use what is called an interference fit. Finally, over time the beam will move and naturally tighten around the brackets. You can use a glue with it too for peace of mind, but it is not necessary.
@@celtic_timber Thanks, I thought as much. So removing it is just a case of prising it off, eventually.
Hi what size drill bits are required? There is a banner on the video that is confusing.
Plaster Board, small dab then chimney breast? Still ok or drill a bit deeper celtic timber?
@@darrenwilkinson9664 10mm masonry bit for the wall, 13mm wood bit for the timber