2001 Maxima - "Mad Max" idle problems - idle air volume re-learn procedure
Vložit
- čas přidán 14. 02. 2021
- 2001 Nissan Maxima idle problems
P0505 and general idle problems that showed up after major work.
In my case I had to replace air intake boot, tighten throttle cable bolts and do a idle air volume relearn procedure.
- throttle cable was loose leading to a sticky throttle
- Air intake Intake boot crack and broken prices. (New intake boot solved the p0505 error. Others may have to replace the IAC (idle air control) part if it’s really bad see this video for IAC • ⭐ P0505 - Idle Air Con...
- After throttle body was cleaned
Nissan Maxima Idle Air Volume Learning Procedure for 2000-2001 Maxima only.
www.nissanhelp.com/diy/maxima...
The information contained in this video is “AS IS” use at your own risk.
#MadMax
#IdleAirVolumeReLearn
#Maxima - Jak na to + styl
Great video!!! Thank you
You are so welcome!
this workss i just did valve covers
thanks for the information
I had the same problem with the air tube cracked and it would jump everywhere when taking off
Yep I had that as well it throws off the air flow volume the cause it’s after the MAF sensor and the computer doesn’t know how to set the fuel trims.
Where is the pcv valve located?
On the rear valve cover near the throttle body. Location varies between each engine design
On this one see about 4:40 in the vid
That is nuts.
Yep, but that’s how nissian did it. They have a lot of other crazy relearn procedures that can be done without an advanced scanner I have heard. The only other I know of is how to reset the air bag light with the key to the car.
I'm experiencing this kind of problem as well. I'm thinking of using a wd40 to lube the throttle cable. Will it help?
No, Look for air leak, difficult to find. If the cable was an issue the cable motion would be hindered
I have the same issue and also if i use the car for 30 mnt or more then suddenly gear will not change speed will stuck on speed one if i off car for one mnt again start it will be normall some time i will press sudden more petrol it will change to second speed normally so what is the issue and how to fix it ?
This sounds like a transmission issue . Check fluid level and quality.
Speed sensor behind driver front tire easy fix thank me later
mine keep rev up and down 1000 - 2000 .. by its own
did the rest no help 😓
Could be a air leak or the IAC. P0505
@@dfields9511 its scary when i searched the failure of IAC that burning ECU because of water shortage .
i disconnected the battery & i will leave it for overnight .
Yah it will burn up the ECU if it’s run too long that way.
@@salsinger9985 also check the MAF sensor . If you end up having to get a new one. Use only OE part. Aftermarket ones can cause problems .
@@dfields9511 isn't MAF sensor when it faulty the car will shut down & won't start unless its unplugged ?
it happened to me multiple times over about 20 years
I think I found my issues lol
Better than no start I think
The auto parts store didn’t have one? Did it ever occur to go to a Nissan dealer ? Stupid people should leave cars alone and keep your day job!
The grommets auto parts store didn’t have one for it so I got it at dealer.
the pcv hose auto parts store didn’t have it but the one I got was the close enough to work. It’s not a specialty shaped hose.
As far as how it broke
The. Old hoses and grommet was so old as brittle it just fell apart just by touching it. The PVC valve really needed replacement anyways. After replacing it burns a lot less oil.
@@dfields9511 yo I got a 2001 maxima 20th anniversary. I put new brakes alternator battery oil. I really need the vapor canister the car still has power.. but since the canister isn’t putting gas fumes back in the engine I can tell it’s not at the peak performance it could be.. I’ll eventually replace it but do you think I’ll get that extra pep back to the car
Not everyone can afford to go to a mechanic. Don’t quit your day job. I’m not a mechanic and I’m working on my car, if it’s a sensor then I take it in.
Yo
YO