Differential Pressure Transmitter (DPT) calibration with sensor and analog trimming_3051(PART 3)

This video is intended for beginners.

[@ManuWeihiruku]

Good update❤

[@niloyu105]

Ok Kabayan suporta lang ako. Watching here Al Khafji Saudi Arabia

[@armaiboi]

salamat po kabayan.

[@rrj2970]

Best explaination sir! Do more video ya regarding E&I. Love it!

[@saravananpratheeba6099]

very good explanation

[@Usman.9234]

Good information sir 👍

[@mrrafiq2018]

Best explaination! Tq sir

[@vinodchauhan3045]

Perfect video for doubt clearing

[@armaiboi]

thanks for watching

[@AHMEDALKURDI45]

Thk bro is perfect ❤

[@saravananpratheeba6099]

thank you very good explanation

[@armaiboi]

thanks for watching

[@PesMobile-xm4gc]

Sir, what is the difference between D/A trim and scaled D/A trim?

[@dayarao1555]

Good informative...request from u can u make meriam hart device

[@abysebastian2597]

Excellent explanation.. thank you so much sir

[@armaiboi]

you're welcome sir

[@abysebastian2597]

@@armaiboi Sir ,pls upload the calibration video for PT, LT, FT also..

[@praful7789]

Sir can you make video on smart temperature transmitter calibration video
You provide great information 🙏

[@armaiboi]

yes my friend if i have time. thanks for watching

[@mgabro9564]

Why i get applied value was too low?

[@pinoycalibrationmaster]

Salamat master
Resbak support naman sakin

[@mgabro9564]

How did you drift the output?

[@armaiboi]

just modify change the current value either in zero or span when doing anlog scaling

[@mgabro9564]

@@armaiboi paano mo ginawang 3.1

[@armaiboi]

@@mgabro9564 balikan mo yung video start at 4:36. instead e correct mo yung value, ibahin mo.

[@mgabro9564]

May inadjust ka sa transmitter para maging 3.1 yung reading sa transmitter?

[@armaiboi]

yes, but not shown in the video.

[@olivertria3025]

sir salamat sa pagshare ng vedio. tanong po sa loop bad at transmitter fault paano po troubleshoot.

[@armaiboi]

hello sir.. salamat po sa pag view ng video.. ano po ibig nyo sabihin? yung pag mag bad PV ang signal ng transmitter?

[@olivertria3025]

@@armaiboi sir nagpre loop po kami . 3051 pressure transmitter 0-120 kg/cm2 cal. range. ok naman po un simulation field to computer room. kaso lang po talaga may BAD n lumilitaw sa local display ng transmitter.. salamat po.

[@armaiboi]

nung may Bad sa local display ano ang current output nya papuntang DCS?

[@olivertria3025]

@@armaiboi sorry po sir diko natandaan un current output. iba po kc un display ng trex sa overview bagong gamit ko palang kc.. di po tulad ng display ng 475 nakikita sa overview un current. balikan ko bukas un transmitter.

[@armaiboi]

sir, try nyo ko e message sa whatsapp [phone]

[@worldinstrumentationengineer]

czcams.com/video/3tetiTopArI/video.html BAHUT ASSA VIIIII~PREM SE BOLO RADHE−RADHEE