Video není dostupné.
Omlouváme se.
Další v pořadí
Automatické přehrávání
Why Nissan CVTs FAILspeedkar99
zhlédnutí 5M
Datsun 280Z 5 Speed Transmission RebuildGreg Oslund
zhlédnutí 18K
Synchronizer Operation ExplainedDrivelineMaster
zhlédnutí 487K
I'm Excited To see If Kelly Can Meet This Challenge!Mini Katana
zhlédnutí 34M
GAME OF O.U.T. vs MINI CELINE 🙈⚽️Celine Dept
zhlédnutí 28M
Eleftherios Petrounias helped by Arthur Zanetti = epic gala moment ❤️Olympics
zhlédnutí 48M
CO TVOJE TĚLO NEDOKÁŽE UDĚLAT (ALE MĚLO BY TO UMĚT) 😅🤣Stejk
zhlédnutí 284K
Manual Transmission OperationWeberAuto
zhlédnutí 10M
Terrific Mass Production of Mild Steel Tractor Nut Bolt | Amazing Production of Tractor BoltsMechanical Craft
zhlédnutí 101K
How a Manual Transmission and Clutch WorksAnimagraffs
zhlédnutí 3,3M
What actually happens when you overfill your motor oil? (w/ transparent oil pan)Garage 54
zhlédnutí 4,3M
The Ingenious Mechanics of DriveshaftsNew Mind
zhlédnutí 359K
Planetary Gear Set Operation - AUSV 2520WeberAuto
zhlédnutí 1,7M
Datsun 280zx 5-speed Trans Rebuild (Datsun 510 Ep 79)Aaron Warren's DIY Garage
zhlédnutí 3,1K
How Manual Transmission works - automotive technician shiftingThe Engineering Mindset
zhlédnutí 4,1M
Chain Drive vs Belt Drive vs Shaft Drive in Motorcycles | Which is Better?The Engineers Post
zhlédnutí 4,1M
Joker can't swim!#joker #shortsUntitled Joker
zhlédnutí 37M
How Countries eat spaghettiLionfield
zhlédnutí 13M
Koupím Barče Cokoliv Co Trefí Šipkou!DodoCZ
zhlédnutí 134K
Chocolate Screwdriver! 🔩 Always have the right tool for the job! #amauryguichon #chocolateAmaury Guichon
zhlédnutí 44M
Ne jamais regarder une fille à la plage 😂Nicocapone
zhlédnutí 7M
Here’s why first responders are calling her a hero.KSDK News
zhlédnutí 43M
STEP CHALLENGE🦶Celine & Michiel
zhlédnutí 7M
11 year TRICKS Magnus Carlsen? 😱 #magnuscarlsen #chessChessBase India
zhlédnutí 13M
howd you reinstall the out put shaft bearing?
you and villageland both kind of cut to the next scene and its installed
Used a press for most of the bearings. Only thing that did not was the inner race for the 5th gear needle bearing, that was done using a series of washers. If you are talking about the last end bearing on the output shaft, I just don't recall, may have used a press and supported the output shaft before installing the input shaft.
you are right I went back and looked at pt 12 shows the input shaft on and the last output shaft still missing that last bearing. I just don't recall. Perhaps it was not a tight press fit, there are C clips on either side, so maybe it was a loose press fit. I would prob just heat it in the oven to about 200f and see if it would not slide on.