DIY: Bow Stand from PVC pipe

[@TheBluePepper]

You guys have the best set up I've seen so far!

[@mastervolume1508]

This is by no means an insult or trolling type of thing. But to my own surprise I have found that a regular hand held wood saw cuts PVC much easier and smoother than a hack saw. I make Bows out of PVC and discovered this by accident. Nice project. I will definitely need the 'Drink" holders.

[@TonyHansen_MI]

+Master Volume I agree. A wood saw works just fine.

[@davidhefner5668]

Don't glue it. Run a single screw in each joint. That way you can make a different design down the road if need be. Those fittings are going to get more expensive soon.

[@tgrif04]

what are the dimensions of all the pipe pieces? Plans are no good without the dimensions.

[@patcochran3284]

Thomas Griffin , I had the same issue, but then rewatched the video. You need four 6 inch pieces for the ends, four 10 inch pieces for the sides. I used 24 inch sections for arrow holders, 26 inch section below the wye and 18 inch section above the wye. Brace piece was cut to fit. Bow hangers I cut at 8 inches. Hope it helps.