I have never made a negative comment or disliked a video before. This video was extremely hard to follow and you made a lot of changes without explaining what they were. I had to keep pausing because you were going so quickly. This wasn't very helpful.
You are a very clear instructor. Thank you. I will be back for more!
You made that so much easier than I was making it out to be. Thank you!
Thank you. This one is very easy among all video tutorial about pipe making
Thank you. I just needed to know why we use sweep to review solidworks. You were straight to the point
Great, this saved my a few hours of work!
Thank you so much from Malaysia ! Appreciate it!
I have been looking for this took a long time, thank you!
Thank you for your neat explanation.
Thank you so much! Very helpful.
Thank you for the lesson! You go a little fast in a couple spots, because you know it so well.
the radius of the fillet tip really works a charm.in SW2016 it gives an error prompt.thanks again
Great tutorial. thank you!
I too love your happy voice! Also, my sweep wasn't working. I think it was the fillets, and you fixed that. Thanks.
Great tutorial and very clear explanation…
Thank you very much 9 years later!! :))
Nice! super helpful!
Thank you very much.Your explane is very good.
Very helpful vid, thanks
this help me for easy understanding
Thank you so much
excellent video, Nice vocal too. thanks
Thanks a lot!
i am in love with you, helped me very muchh :) :) :)
Very helpful
Life saver
Very nice this lecture sir
Many many Thanks mam......
thanks, Nice Tutoriall :)
Thanks for make this video
nice tutorial thank you
wow thanks a lot!!!!!!!
Omg Thanks🤙🤙🤙🖤
I didn't know about the constraints on the fillet radius. Thanks
+Brandon Semerau
My pleasure glad to help.
thanks a lot
good thanks
this all goes in one direction, how would you make it so there would be bends that go into different planes?
Use a 3d sketch
czcams.com/video/fE-Gffjm9To/video.html&feature=emb_title
Weldon sir
Love the music of your voice .
How would you create an object where the tube is cut so that all is left is a U shape?
Refer to 0:50. Do the exact same thing, except instead of making those two circles, make a U shape.
Could someone please éxodo because the tutorial did not go over that senario
Sweep tool is greyed out idk y
Thank you for the help. I would give you commission, but I am working for an unpaid internship!
nuhunn
question.. how would you end with a 45degree cut instead of standard straight 90deg cut?
Very clear and cute voice
WHAT SOFTWARE ARE YOU USING?
SolidWorks 2015
Does it have to be a circle?
No it can be any shape you like, as long as your path curve(s) aren't too tight
Very hot voice ! :))
Thx for tutorial . Good Job !
Ohhhhh uwwwwwweeee uewuwuuww you save me
Mmmmmmmmmmmm yahhhhhhhhhhhhhhhhh daddddddy
voice....
Your voice ❤️
Very cute voice
cute voice
So?
imagine simping on solidworks tutorials
do full chair in 3d with angles on side , front, backsurface parameters, etc... not flat tube.
M
who is here watching from university of Ghana
Do you like beetles??
Kenny Awere
I prefer Beatles.
Engineering go to hell.
I'm crushed on that voice.
That is true
So it isn;t just me?! man, i wish she could tell me bed time stories!
NO VOCAL FRY AND JUST A BEAUTIFUL TONE.. CAME TO LEARN SWEEP AND STAYED FOR THE SOUND
I have never made a negative comment or disliked a video before. This video was extremely hard to follow and you made a lot of changes without explaining what they were. I had to keep pausing because you were going so quickly. This wasn't very helpful.