How to overmold magnetic connector with pogo pins

Overmolding is a specific injection molding process where we inject molted plastic around a component. Therefore, we place the component to be overmolded in an injection mold. The molten plastic, usually has a lower melting temperature than commonly used plastic raw materials.
In this video we show how to overmold a magnetic connector with pogo pins. The overmolding happens in 2 steps. Each molding cycle finishes the 2 steps at once. As you can see, it is a repetitive process.
#overmolding #injectionmolding #insertmolding #connectormanufacturing
www.davantech.com/insert-mold...

[@Technoboy928]

Do the magnets not lose their magnetic strength due to the injection moulding heat?

[@AliMir211]

does it rubber molded?

[@qrubmeeaz]

Infuriating!! Could't see any of the important stuff. Useless video.

[@davantechengineering]

We can always improve. Could you clarify what would be the important stuff to see?