2010 Chrysler Town and Country HVAC Actuator replacement
Vložit
- čas přidán 26. 08. 2024
- Replacement of Blend Door actuator on a 2010 Chrysler Town and Country mini van.
Due to factors beyond the control of CharlesAndCars, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. CharlesAndCars assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. CharlesAndCars recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of CharlesAndCars, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not CharlesAndCars
My daughter and I did this repair yesterday. It was a bit of a challenge but this video was a HUGE help in diagnosis and repair of the actuator door. Great video!
glad it helped
God I replace everything compressor condenser dryer valve expansion now thanks to you just found out doesn’t work thank you very much for your help
I just did this for my wife’s van. Major pain in the ass but it worked. Thanks so much!!!
I have 2006 town and country, blower works, replaced months ago but no air or heat (wind) coming out of any front vents, defrost, dash or floor. Enjoyed the video Thanks
A very useful video to diagnose and fix an air mixture issue on the passenger side. Thankfully a fairly simple/easy fix. Thanks!
Glad it helped
In my 2010 Town and Country, the front row gets ice cold with the ac on, the 3rd row is cool but the middle row feels like the heat is coming from the vents! I found your video helpful and am going to change the actuator to see if that helps!
I have a 2010 with a 4.0 but my clicking is on the driver side somewhere just behind or to the right of the ignition . I'm too big to get in there and the clicking seems to be hidden by something plastic I would just disconnect it for now but I can't even see the wire it starts clicking every time I start the engine and then quits after a a few minutes
What mode did you have to select to move that actuator, and what issue did it have other than clicking?
No AC or cold on one side?
Why did you do this at night? Very hard to see.
Hello, I had this problem, I heard that click but it went away, what now happened is that my air cools but only on the right side, my left side is only hot air, does this system have 2 actuators or will I have a different problem? As I mentioned, the click was identical, I stop doing it but cold air does not come out of the left side. This video is very helpful.
It's hard to say exactly what it is. You have multiple actuators, (temp,position--defrost, mid,low), etc. Could be one of them stopped working all together. Also low ac charge can cause cool on one side and not on the other...
Should we disconnect the battery first? Or is it okay to leave the battery connected while doing the work.
Don't have to disconnect battery
I have a 2016 Chrysler T&C, my noise is coming from behind the glove box too but it isn’t a fast click but more of a slow whirring or rubbing noise that goes away after 10-20 seconds. Could that be the same part or something entirely different?
Hard to say
Where is the cabin air filter located on this vehicle?
2010 Chrysler Town and Country 3.3 Doesn’t have one
Can you show me the a/c filter on 2010? Can’t find vids for the 2010..my a/c is working but not super cold.. left side warmer than right. Thought I would start with the filter..thank you!
Wouldn't think it's the filter. Have the pressure in the AC system checked. One side warmer than other can point to low pressure in the system.
There is NO filter..not on thd 2010 year model.
greetings to me a question I have a chrysler country town minivan 2010 and I want to change the heating air filter but I don't know where it is, can you tell me please, thank you, God bless you
Some 2010s have cabin air filters and some don't. It will be behind the glove box if it has one.
Does this actuator need calibrated?
No, there's no special procedure to run through, that I remember.
Is this a 4.0 engine?
3.8L
God I replace everything compressor condenser dryer valve expansion now thanks to you just found out doesn’t work thank you very much for your help