Hummer H2 Replacement Remote Programming 2008 2009
Vložit
- čas přidán 3. 08. 2024
- Visit us at www.carandtruckremotes.com/
Programming Instructions for a Hummer H2 Replacement Remote Programming 2008 2009
Switch Hummer H2 ignition ON.
Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.
Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.
Programming mode activated, proceed as follows:
Press and hold LOCK and UNLOCK Hummer H2 remote buttons on first remote transmitter simultaneously for 15 seconds.
Wait for acoustic signal (indicates correct programming).
Repeat above procedure to program remaining remote transmitters.
Switch Hummer H2 ignition OFF to exit programming mode.
Remote transmitters can also be programmed using diagnostic equipment.
NOTE: A maximum of 8 Hummer H2 remote transmitters can be programmed. - Auta a dopravní prostředky
Thank You.
Why did you post this for Hummer? Its not the same
Don't work on 09 hummer ht3 truck
Didn't work on my 2008 either