Easy Tracksaw Router Guide

In this video I show you how to make a helpful jig so you can use your router with your tracksaw!
Instagram: smallspacec...

[@cornhole1335]

Ingenious! Thanks for putting this together and sharing your idea!

[@smallspacecreation5768]

Thanks for watching 👍👍👍

[@alanmooney]

Great idea, a lot less costly than a festool part

[@smallspacecreation5768]

Thank you 👍👍

[@ronsnyder2209]

Great design. Thank you for sharing.

[@smallspacecreation5768]

Thank you glad you found it helpful 👍👍👍

[@robgormley1317]

Absolutely brilliant Mark I was thinking of doing something along the Same lines but I love the nice simple design wheby as you said having the ease of being able to detach the router and without loosing any of the depth adjustment if the router was mounted onto a piece of MDF. Thanks again for sharing your idea 👍

[@smallspacecreation5768]

Thanks for watching Rob glad you found it useful 👍👍

[@mikeharper1102]

Could've used that today cutting v-groove into MDF, would've saved me going back with filler where I wasn't paying attention 🤬 looks like it works tho so good job👍

[@smallspacecreation5768]

Thanks for watching please check out my other videos 😁

[@YouGumppy]

I believe you have demonstrated the sole remaining justification for a tablesaw in my shop.

[@smallspacecreation5768]

Thanks for watching

[@ohcrapitsmrG]

You make a lot of interest video

[@smallspacecreation5768]

Thank you please subscribe got some more coming 👍

[@normancoutts]

Very useful I’m sure. Well worth doing. Cheers.

[@smallspacecreation5768]

Thanks for watching yes can save a lot of time when you need it 👍

[@joncarter3038]

Just had a look at your channel on the recommendation of 'Rag n Bone Brown'. Triton make one of these for their router, which then connects to the saw track. It has a micro adjustment to it etc. I'm guessing that it might well fit the Festool track as well but im not sure of its compatibility with non Triton brand routers. Thanks for the videos. You have a good channel with lots of interesting stuff so a new subscriber.

[@smallspacecreation5768]

Thanks for watching and subscribing

[@cognitor900]

Looking good.

[@smallspacecreation5768]

Thank you 👍

[@myfaceback100]

great use of scraps small suggestion I would make is use 2 nylon screws on the router side of the connector
so you can remove the wobble that will come from using it as you can adjust them to take up the gap like on the track saw to the rail

[@smallspacecreation5768]

Thanks for the suggestion 👍