I have Arturia Audio Fuse Studio. Can I connect two interfaces by adding the Arturia 16Rig interface to my Mac? whether all inputs and outputs in both interfaces will be visible in Audio Fuse Control Center and Ableton. Will it be Plug&Play or do I need to install any additional drivers?
So, from what I'm gathering, you cannot both listen to audio from your computer _and_ monitor inputs _without_ a daw, which is incredibly disappointing since most interfaces allow this kind of pass through/custom mixes. Please tell me I'm wrong.
is it possible, to route the different inputs to the individual outputs? example; input 1/2 and 3/4 go to output 3/4, input 7/8 go to output 5/6. ...something like group sends.
It is not possible. I have the 16rig. Outputs can only receive 1 input. i.e output 3/4 can only receive input 1/2. But input 1/2 can go to Output 3/4, 5/6, 7/8, etc.
Is there an update for the Audiofuse 8pre control center???
proper unit , and so clear explanations
I have Arturia Audio Fuse Studio. Can I connect two interfaces by adding the Arturia 16Rig interface to my Mac? whether all inputs and outputs in both interfaces will be visible in Audio Fuse Control Center and Ableton. Will it be Plug&Play or do I need to install any additional drivers?
So, from what I'm gathering, you cannot both listen to audio from your computer _and_ monitor inputs _without_ a daw, which is incredibly disappointing since most interfaces allow this kind of pass through/custom mixes. Please tell me I'm wrong.
What's about Loopback? Does it has internal DSP effects?
@Arturia can U switch presets via MIDI or global key commands?
Still can't figure out how to use the Aux sends. Trying to use with a QuadraVerb and AF in standalone mode.
Can someone recommend a good midi control surface with motorized faders that would work well for this? Preferably with knobs for Aux/Pan as well
Console 1 & Console Fader 1 :)
is it possible, to route the different inputs to the individual outputs? example; input 1/2 and 3/4 go to output 3/4, input 7/8 go to output 5/6. ...something like group sends.
It is not possible. I have the 16rig. Outputs can only receive 1 input. i.e output 3/4 can only receive input 1/2. But input 1/2 can go to Output 3/4, 5/6, 7/8, etc.