Video není dostupné.
Omlouváme se.
SCOTT Prospect WFS Works Film System Installation Tutorial
Vložit
- čas přidán 11. 12. 2018
- A how-to, instructional video explaining the instillation of the Scott Prospect WFS, Works Film System. Using our double post works lens you simply snap on the grid system along with the canisters and slide the 50MM film under the mud flap and off you go.
SCOTT Prospect WFS: www.scott-spor...
SCOTT WFS Kit: www.scott-spor...
Guy is a natural! Dope hand tatts
Great help ! Thank you!!!
Those silica packs, the things that come in the packages and say do not eat, I put those in the goggle bag with the goggles after they have tear offs on. They are supposed to absorb moisture, I think it helps a little bit with moisture build up under the tear offs. even the tiniest amount of moisture will leave kinda a film between tear offs on any kind of goggle, This is less an issue with the laminated stacks. Anyway I put a few in with the WFS goggles, they tend to sit awhile in my Scott goggle case til I gotta pull them out for a mudder, but I do this with all my goggles. Just from humidity and air flow it can get a little film of moisture between tear offs, II think it helps a little bit, and they basically come in everything you order that comes in a box, so don't have to buy the silica packs. just don't eat them haha
good tip! as long as it doesnt leave a dust on the lens..
Bought the Fury WFS complete and the first film install went smooth thanks to the vid 👍. Why don't the goggles include a protective bag?
Same thought. Just opened up box and first thing I noticed was no bag. Disappointing.
Thanks for the little tips !
can this system be mounted to other goggle brands? i have scott but if i am in a bind
Now wishing I had these goggles
They not too good no worries bro
How do you fix peeling foam of the prospect
Normal for the outriggers to not sit right with the roll off canisters??
Great goggle to have in your gear bag for those motos that you do in the pouring rain or deep mud. Put a couple tear offs on for the start cause massive build up will build up at the slide side side, Only time it was an issue was first mud moto I did in them, I only had one tear off on and it was soaked by the the time the gate dropped, anyway I pulled the tear off before the race, than a mid pack start on a full gate, I got blasted by about 20 450s, Great product, just put a tearoff or 2 on for the start. handles normal roost just fine, the fact I got blasted by about 20 450s at the start that one moto, there was a little bit of build up on the receiving side lol. But anyway since then I've had to use them a few times, and they work great. Sooner or later or your gonna have a mud moto, don't trust the weathermen, Have at least one of these loaded and ready. Don't ever take your goggles off. I've had roost punch a hole in my clutch cover (didn't realize it till after the moto, my footpeg felt really slick, but I lost all my tranny oil, luckily that bike , 09 honda 450 had separate engine and transmission oil, still probally wasn't to great for the tranny) anyway looked like a bullet hole through the case, I still have it as a souvenier, looks like a 22 round went through the case cover. With these you shouldn't ever have to take your goggles off. Sooner or later you'll be doing a mud moto, and mud sucks, but it's way better when you can see so I highly recommend keeping a wfs loaded and ready!
My roll off kit didn't come with the mud flap thing
How many pulls do you get with one canister?
For 25 in Rocky Mountain right now. Take my money
Why it doesn’t roll anymore even with a new film?
must've done something wrong. I just reloaded a pair, I double checked the this, I didn't have any issues? I'd check the little pins are completely in, open the canister cases should be able to figure it out, bet the pins aren't in the gear or the receiver end isn't attached. it was 11 months ago, curious what issue was? I never had any problems. What was it?
@@eli9494 I never work out again it got like stuck and they I broken and continue using them with out the rolling system still having them on my helmet but without that system
Kinda pain in the ass first time along with dust stuck behind the film. Also makes it fit kinda eh in the fly formula.
How do you remove the glass bcs you can’t remove it with the roll off system still on? Do you need to remove the hole roll off system to remove the glass?
Remove the glass ? You have glass lenses Are they heavy ? Bullet proof?
Timmy L dont be such a dick, you know what he means
You can remove the lens with the WFS system still mounted on
Can I use them for MTB?
sure you can!
mantapPpPp 👍
Will this kit fit on the Scott Prospect google?
He's using a Prospect in this video...
This goggle is Trash.
I cleaned the inside with a microfiber cloth and now it's totally scratched inside you can't really see through it anymore. this is the only pair of glasses that does this. too bad
They really are garbage these days. Such a pain in the ass
Worst fitting goggles ever.