MA01. [AB Motion Control] Setup Motion Control Project and Create Virtual Axis in Studio 5000 [1/10]

#RSLogix #Studio #Motion
Motion Control Playlist: • Motion Control
Allen Bradley Playlist: • Allen Bradley Controls
In this video, it introduces how to setup a Motion Control project and how to create a Virtual Axis in Rockwell Studio 5000.
MA01. [AB Motion Control] Setup Motion Control Project and Create Virtual Axis [1/10]
• MA01. [AB Motion Contr...
MA02. [AB Motion Control] Online Test Axis - Motion Direct Command in Studio 5000 [2/10]
• MA02. [AB Motion Contr...
MA03. [AB Motion Control] Prepare Motion Control Variables - Import Data Type Template [3/10]
• MA03. [AB Motion Contr...
MA04a. [AB Motion Control] Motion Instructions Reset, Servo ON, Jog, and Stop [4/10]
• MA04a. [AB Motion Cont...
MA04b. [AB Motion Control] Motion Instructions MAM Absolute Position Control [5/10]
• MA04b. [AB Motion Cont...
MA04c. [AB Motion Control] Motion Control Instructions - Online Test [6/10]
• MA04c. [AB Motion Cont...
MA04d. [AB Motion Control] Motion Control Status - Standstill and At Position [7/10]
• MA04d. [AB Motion Cont...
MA05. [AB Motion Control] Trend Curve in RSLogix 5000 and Studio 5000 [8/10]
• MA05. [AB Motion Contr...
MA06. [AB Motion Control] Sequence Control Application [9/10]
• MA06. [AB Motion Contr...

[@jameserayburn]

Wonderful explainations!

[@electricalautomation]

Thanks for watching!

[@hetanhawke2354]

THANKS MR

[@electricalautomation]

Thanks!

[@disun4152]

Thank you for the video. Can you recommend a software that can read IP address by MAC address if the controller is not brand-new, out of the box.

[@electricalautomation]

Try Siemens "PRONETA", it is a free network software

[@mekbots7607]

Hi shane : how to set motor position set just from 0 to 360 after 360 start again from 0 . thanks a lot

[@electricalautomation]

Hey, here is EAH channel, I am not shane. For your question, in other brand of motion, it is named 'modulo', for Allen Bradley, you can check rotary -> position unwind.

[@demurch0]

What software edition do you need for Motion Control? Standard, full or Professionally.
Thanks.

[@electricalautomation]

pls find the link literature.rockwellautomation.com/idc/groups/literature/documents/qr/9324-qr001_-en-p.pdf. I used Professional version. But FULL and PRO should be common.

[@fernandomatiasn]

Hi, could you help me create a virtual axis from the movement of an encoder (which enters through an HSC module) and then gear it to a physical axis of a Kinetic 6000. I can't find how to modify the movement of a virtual axis other than by direct commands

[@electricalautomation]

I would recommend contacting Allen Bradley tech support for your question.

[@vorapobautomation9760]

Where is the next video please ?

[@electricalautomation]

The links can be found under the video
Motion Control Playlist: czcams.com/play/PL762SfoJC-e8NbAUQ-H7a_TOdqrlBPCw4.html
Allen Bradley Playlist: czcams.com/play/PL762SfoJC-e8Ofun9xqHGRVCVsqacTKVj.html