Welp...not having luck. Everything was going great until I went to install the bearing plate on the input shaft. Lower was fine, but upper was 1mm out of alignment with the bore. When installing the race it only goes halfway into bore. If you force it, the shaft binds. Ugh...super frustrating!
Welp...not having luck. Everything was going great until I went to install the bearing plate on the input shaft. Lower was fine, but upper was 1mm out of alignment with the bore. When installing the race it only goes halfway into bore. If you force it, the shaft binds. Ugh...super frustrating!
Never mind working on this. Finish off the 84 RM500 thanks.