DeWalt DWE7492 - adding extension table and installing a nice big drawer...

DeWalt DWE7492 - adding extension table and installing a nice big drawer... I continue expanding my table saw working station. In this video I share a very easy and effective way to build a small supporting construction on the outfeed side of the saw. I also install nice and space drawer just below. This element will require some minor adjustments as I am not 100 % happy with the result.
Enjoy!

[@johnvodopija]

Nice build! The outfeed extension looks superb. Cheers 👍😎🇦🇺

[@kurthougaard557]

Endelig en video med mål👍

[@SeanChYT]

Beware. I had the same type of digital level gauge (I think...), but I recently discovered it was really not very accurate Almost 0.7 degrees off when measuring normally, just using the bottom face, the magnetic one. Always good to double-check. One particular weird thing about it was that it also showed over 3 degrees different when rotating it 180 degrees while it was stuck magnetically to the blade. It also was 1 degree off when placed upside down, and showed nearly 1 degrees different if I measured on the opposite side of the blade (still referencing the bottom face).

[@kurthougaard557]

Endelig en video med nogle mål 👍

[@StamosTee]

Really nice addition 👍 But , please buddy, be more careful with the table saw. I noticed a few critical mistakes against your safety. 🤜🤛

[@mumihp]

me as well, his fingers were to close to the blade when he was using the cross jig, should use a push stick.

[@johnvine5731]

And 2:56 with the push stick

[@marcenariacriativamonicaar8415]

Gold job!

[@cahngalamkarlos2595]

Thank bro

[@adrianaosirish6065]

Good job !!

[@michaelandersen1161]

nice video, what drawing tool are you using to create the drawing sketches shown in the video ?

[@zolatanaffa87]

Nice job indeed, but where the upper parts of the extension supports hang, I have not seen your solution well.

[@midnightsun2483]

Round over your edges on your out feed extension

[@amaurialves76]

Parabéns!
Tem como disponibilizar o projeto?
Obrigado.

[@VladimirLavrinenko]

Понравилось!

[@soarebv]

👍

[@jimchen7382]

Really smat design！May I have the outfeed extension sharp3D file?

[@ChristenGC]

I like your table but I'm wondering, isn't it unstable on wheels ? Can you cut full size plywood on that thing ?

[@mmposhumer2535]

Thanks. I did not try it yet but it might be too small to handle such big sheets.

[@norbertkarnay9098]

@@mmposhumer2535 I consider to make something similar, but definitely with brakes on the front wheels

[@kamhaq]

Buddy crosscutting without miter, buddy you are lucky no kick back happened, beside that I love the stand and extension I'll follow same once I get mine next month. I think you may need to extend t slot to extension if you need to use sled

[@adrianaosirish6065]

He did use the miter gauge ...look again !!

[@HepauDK]

@@adrianaosirish6065 Yes, he did use the mitre gauge, but the comment was about a sled. A sled is considarably bigger...

[@joaoluis1744]

muito fixe

[@Bernycoty]

ca manque de plan et de détail de montage !

[@mayamashi6055]

👍