How to rebuild a KTM rear brake pedal / DirtBikeDudeZ
Vložit
- čas přidán 5. 09. 2024
- I´m showing you how to repair / rebuild a KTM rear brake pedal.
How to change KTM rear brake pedal bearings.
Shown on a 2006 KTM EXC 300.
!!!KEEP ON BRAAAAPIN!!!
DirtBikeDudeZ
There was a good inch of sixe to sude movement in mine when I bought it. This helped a lot. Thanks!
Helpful video!! I will look back on this when I need to change my brake lever :)
+Enduro Clutch N Shift Thank´s ;)
Good video! Very helpful! Thanks for sharing!
Good instructions! Break lever gets sloppy and needs a new bushing ! Put the nut back on the bolt so you don't loose it ! Braappp!
+Richard Bolt Exactly! :) It´s a shame the older bikes got no bearings in the brake levers.. When it wobbles, it wobbles :( unless you put a new brake lever on...
No need to remove the frame guard, nice video
Hey idk if you're still around, but do you know the torque spec on that bolt? 1:28
Exactly the video I needed. Sehr gut. Danke.
Where did you order that bearing kit from? Do you think it would fit a 2001 300 exc? Thanks!
Any one here able to help ive recently got a ktm 85 with no rear pedal at all recent brought a pedal the push rod but I don’t have all of it the top of my push rod like the plunger bit I don’t seem to have I feel like I’m missing bits to the bottom of my master cylinder too can anyone help me out with what it’s called or a link to one
Had to turn off due to song language, tender ears.
Hope you can reply to this. But do you know where i can find the part thats on the end of the shaft. The thing that pushes the brake piston up
Hey any joy on locating that part you mentioned?I too am also missing it thanks
www.motorcyclespareparts.eu/en/ktm-parts/54813056000
#15 on diagram I think.
Have to make an account and wait a month though.
Had the same nightmare. Good place for oddball bits.
Good video, you forgot to greeze the bearing
where is part 4 of the $50 yamaha yz250 project?
also if you would have froze those bearings they would have just dropped in with no tapping needed
+DirtBike Daily I know, but don´t have a freezer in my workshop :(
The build series will go on this year :) i finally found the parts for the engine i needed!
good video, can I ask what the grey substance is in the spray can that you are applying to bolts and screws? thanks!
thank´s man :) yeah, it´s anti-seize spray ;)
Wo hast du das alles eigentlich gelernt? :D
+Enrique Gil Ich habe vor über 10 Jahren eine Lehre als 2-Rad Mechaniker gemacht ;)
Music to videos always sucks! Good use of how to even so.
Use power tools save time