Just started this video, can’t wait for you to see the state of the stock top mount bushed when you take them out. No idea who designed them, or what rubber they used, seen the top bush go after as little as 25k
Got to the end, coolant leak usually from the thermostat housing. The oem one has a plastic connector to the rad hoses, always cracks, replace the unit with an aftermarket one, with the metal connector pipe. Other than that 100% replace the timing belt and water pump, seems the oem belt is made from rubber bands, and the aux belt pulley goes too.
got exactly these issues with my Fiat 500 (same colour too) it just failed the MOT because of the shock absorber bushings and emissions due to "Front flexible exhaust joint is leaking this causes a HC fault. As there is a introduction of unburnt air in to the exhaust. Problem also is that the rest of the exhaust is corroded and the rear pipe mounting has corroded off. Vehicle requires a new complete exhaust system." For a new exhaust and new shock absorbers plus labour, the garage quoted me £752.81!
The fiat looks very rusty underneath as well ...recon it got much salt in wintertime ...are you going to do anything about the bottom ...like spraying anti rust and a preventive coating? Just bought one for my daughter a 1.2 from 2011 I hope it's not like yours...😉
I can’t believe they’ve done all that work for the clutch and shocks. Still didn’t change oil... so strange. Thinking you’re loving the little 500, sure you don’t wanna keep it hahaha.
Yes it's very strange one owner from new and many repair bills. But no maintenance work. So I'm going to swap the cam belt too as a precaution. Yes I do quite like it. A bet it will do better MPG than my clk500.
@@vintagesteelgarage Hello, thanks for that I bought this along with new exhaust rubbers but going over bumps it’s hitting the underside of the car now. I believe it’s hitting it just before where the pipe goes down to the joint. Did yours do this too? P.S looking at your video your exhaust seems quite far away from the heat shield where as mine is very close, strange indeed
@@mikemyres No i didn't have any clearance issues. However you can get quite bit of adjustment on how the pipe will run be loosening the clamp and realigning the pipe and then tightening the clamp.
Hi great video, I've just bought a 500 1.2 with 4,000 miles on it. Gonn'a do a light recommissioning do you think some lithium grease on the rear suspension mounts would be good ?.
@@vintagesteelgarage Hi again it’s 2015 colour therapy limited edition ( but it’s really a pop steel wheels and a peashooter exhaust ) a chap bought it new for his daughter and she didn’t want it so I bought it , I hate to see a good car going to waste. A bit different from my former car!!! A Mazda MX5 😊.
@@vintagesteelgarage It is cute-looking but the same issues occur and Fiat don’t correct them.The rear wiper wiring breaking where it pivots by the hatchback,shock absorber top mounts,rear shocks and one of the worst try changing front wishbones-you have to remove the front bumper first!!!Just a poor design.My other daughter’s car aToyota Aygo-no issues in 7 years.Love your channel btw.👍
Yep fully agree and had all those issues already. But it's like the original mini which was a rust trap. Poor access for maintenance etc etc. Now iconic. People love landrovers but they have terrible reliability. Also gives me something to make a video about. Thanks for feedback.
Just started this video, can’t wait for you to see the state of the stock top mount bushed when you take them out. No idea who designed them, or what rubber they used, seen the top bush go after as little as 25k
Other knocking from the back, if the driver reports back is usually from the boot knocking from the boot struts failing
OK thanks for heads up
Got to the end, coolant leak usually from the thermostat housing. The oem one has a plastic connector to the rad hoses, always cracks, replace the unit with an aftermarket one, with the metal connector pipe. Other than that 100% replace the timing belt and water pump, seems the oem belt is made from rubber bands, and the aux belt pulley goes too.
timing belt and pump replaced, thank for other info will watch for that one
love it. top man
Shock absorber failure is enough to dampen anyones spirits. That goes without swaying of course.
Excellent pun
got exactly these issues with my Fiat 500 (same colour too) it just failed the MOT because of the shock absorber bushings and emissions due to "Front flexible exhaust joint is leaking this causes a HC
fault. As there is a introduction of unburnt air in to the
exhaust.
Problem also is that the rest of the exhaust is corroded and the rear pipe mounting has corroded off.
Vehicle requires a new complete exhaust system."
For a new exhaust and new shock absorbers plus labour, the garage quoted me £752.81!
Wow on the garage costs
Yeah I’m gonna do it myself I think
@@SoloTraceur is it the rear shocks?
@@vintagesteelgarageyep rear, both sides
@SoloTraceur quite easy to replace no special tools required.
The fiat looks very rusty underneath as well ...recon it got much salt in wintertime ...are you going to do anything about the bottom ...like spraying anti rust and a preventive coating? Just bought one for my daughter a 1.2 from 2011 I hope it's not like yours...😉
Yes I need to get that done at some point this summer
I can’t believe they’ve done all that work for the clutch and shocks. Still didn’t change oil... so strange.
Thinking you’re loving the little 500, sure you don’t wanna keep it hahaha.
Yes it's very strange one owner from new and many repair bills. But no maintenance work. So I'm going to swap the cam belt too as a precaution. Yes I do quite like it. A bet it will do better MPG than my clk500.
Where did you get the next exhaust from, who makes it and what model number? Thanks :)
I got it from ebay www.ebay.co.uk/itm/143219104409
@@vintagesteelgarage Hello, thanks for that I bought this along with new exhaust rubbers but going over bumps it’s hitting the underside of the car now. I believe it’s hitting it just before where the pipe goes down to the joint. Did yours do this too?
P.S looking at your video your exhaust seems quite far away from the heat shield where as mine is very close, strange indeed
@@mikemyres No i didn't have any clearance issues. However you can get quite bit of adjustment on how the pipe will run be loosening the clamp and realigning the pipe and then tightening the clamp.
Hi great video, I've just bought a 500 1.2 with 4,000 miles on it. Gonn'a do a light recommissioning do you think some lithium grease on the rear suspension mounts would be good ?.
Thanks for feedback. At 4000 mile you should be OK.
@@vintagesteelgarage just a thought, I’ve bought a lot of parts off Shop4Parts in Bradford ( genuine fiat parts at very reasonable prices ).
OK. Thanks for info I'll look them up. What year is your car?
@@vintagesteelgarage Hi again it’s 2015 colour therapy limited edition ( but it’s really a pop steel wheels and a peashooter exhaust ) a chap bought it new for his daughter and she didn’t want it so I bought it , I hate to see a good car going to waste. A bit different from my former car!!! A Mazda MX5 😊.
Enjoy. I bet they'll be future classics. Is that in the beige colour?
It’s been many years since I had a car bouncing like that.
One of the worst cars ever designed.Get a Toyota Aygo or Yaris .I learned the hard way!
I agree , but it has way more kerb appeal than a Yaris. Sometimes practical isn't fun
@@vintagesteelgarage It is cute-looking but the same issues occur and Fiat don’t correct them.The rear wiper wiring breaking where it pivots by the hatchback,shock absorber top mounts,rear shocks and one of the worst try changing front wishbones-you have to remove the front bumper first!!!Just a poor design.My other daughter’s car aToyota Aygo-no issues in 7 years.Love your channel btw.👍
Yep fully agree and had all those issues already. But it's like the original mini which was a rust trap. Poor access for maintenance etc etc. Now iconic. People love landrovers but they have terrible reliability. Also gives me something to make a video about. Thanks for feedback.