2019 F150 Flowmaster American Thunder Exhaust Install

2019 F150 Flowmaster American Thunder Exhaust Install
It's time to make the F150 louder! Today I'm installing a Flowmaster American Thunder Exhaust on the F150. Let's get started!
Contact me: [e-mail]
Flowmaster American Thunder Exhuast www.americantrucks.com/flowma...
________________________________________________________________________
Friends of Project DIY:
Byran Pasley at Bpaz Music: czcams.com/channels/xUX.html...
Steven Scott
Check out Steve's line of guitar pedals here -
reverb.com/shop/sps-pedals
/ spspedals
Steve's farm: / hobbitonfarm
_______________________________________________________________________
Subscribe to my channel so you don't miss a video!
/ @projectdiy2
#F150
#Exhaust
#gregthomas
#projectdiy

[@LakersfanG6PDcst]

Love that sound!!!

[@irisalicea5353]

You can't beat that Flowmaster sound. Nice ride, nice video.
God bless. From the other side of the World. René.

[@ProjectDIY2]

Thank you for the kind comments!!!

[@piazzadriver]

I just installed on my 2021. Interesting your 2019 the exhaust come down from the engine on the drivers side. Mine is passenger side

[@jamesunderdal8976]

Sounds pretty good I think I'm gonna go with the same setup

[@sSMITZ8500]

Been looking for this exact video. Mine arrives this Friday...Thank you thank you

[@ProjectDIY2]

Nice! I ended up adding a resonator to it. It was a little too loud in the cab for my tastes.

[@trailerparkplug1758]

Good timing on the upload lol going to pickup my 19 f150 5.0 on Wednesday . Comparing exhausts at the moment . Thanks for the video

[@ProjectDIY2]

No problem!

[@smoke05s]

Great video. Im going to go with a 40 series and single exit out the back on Saturday. I think I will keep the resonator based on this video. Does sound mean outside but that might get old on the highway without the resonator.

[@ProjectDIY2]

It was definitely too loud for my taste w/o the resonator. You'll like the 40 series 😉

[@jeffbruns7216]

Did you have much problem with impacting the clamps down did mine by hand with a wrench its not tight enough and the joints still move?

[@ProjectDIY2]

Yeah, you gotta use an impact to get them tight enough and then run it for a few days and then tighten them again.

[@johnloux2345]

Did you have to weld a hanger on the other side?? If not what did you do?!

[@ProjectDIY2]

It comes with a hanger that you bolt to the frame.