Easel for Beginners - Your FIRST Project in 6 MINUTES

End to end tutorial taking a concept to product using Inventables Easel and the Onefinity CNC.
🧰 Parts used in this video:
Design File - crgmakes.etsy.com/listing/165...
Whiteside Bowl Bit - amzn.to/48QYxTN
1/4" Uncut End Mill - Amana 46321 - amzn.to/49bvhqQ
1/4" Uncut End Mill - Uptown Jenny - www.cadencemfgdesign.com/prod...
Affinity Designer - affinity.serif.com/en-us/desi...
Onefinity Woodworker - www.onefinitycnc.com/cnc-mach...
Inventables Easel - easel.inventables.com/
Carbide Create - carbide3d.com/carbidecreate/
Fusion 360 - www.autodesk.com/products/fus...
CNC With Me - www.cncwithme.com
Part 1 - Fusion - • Fusion for Beginners -...
Part 2 - Carbide Create - • Carbide Create for Beg...
Future of Free Software - • Is truly free software...
Does Chip load Matter - • The ONE parameter will...
#tutorial #endtoend #easel #inventables #onefinity #beginners
0:00 - Introduction
1:40 - Easel Overview
2:49 - Easel Setup
4:15 - Importing SVG
5:59 - Cut Settings
7:14 - Bit Settings
12:02 - Exporting g-code
15:13 - Onefinity Upload
15:51 - Fixing Mistakes
20:27 - Making
21:26 - Raw Results
23:08 - Final Results
25:28 - Comparing 3 Programs
26:25 - Recommendations
❤️ If you find my content helpful, become a channel member to get access to members only content @cyberreefguru
🔔 Subscribe for more free videos:
czcams.com/users/cyberreefguru...
🧰 All my Tools and Gear 🧰
kit.co/cyberreefguru
👉 All my websites and socials 👈
linktr.ee/cyberreefguru
Don't forget to subscribe and ring that bell!
Music by:
ampletunes.com and Epidemic Sound
Disclaimer: Some of these links go to one of my websites and some are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you.

[@JavierDeJesusSr]

was not able to find the SVG at the link. Do I have to signup for CNC with Me to get the file? If so, is there a similar file I could us?

[@cyberreefguru]

Hi Javier - I'm working with Hamilton (@HamiltonDilbeck) to figure out the details. I do believe you need to be a member to have access to the file. Alternatively, I did upload it to my Etsy site as well: crgmakes.etsy.com/listing/1676459433/dog-paw-design-files - thank for watching!

[@JavierDeJesusSr]

Made some customizations. Was not able to avoid the ridges at the bottom of the bowl pockets in Easel. Know how?

[@cyberreefguru]

Hi Javier - I'm not sure with Easel. You can 'hack' the system by telling Easel the bit is smaller than it actually is (like 5/8" instead of 3/4"), but the proper way would be setting the step over, which Easel does not seem to support or observe. A little sanding with something like this -> amzn.to/49dZAgh fixed any issues I had. Hope that helps -- if I find a more solid answer I will let you know.