Metal Lathe 111 Operation Basics, Facing & Turning Review plus Drilling
Vložit
- čas přidán 21. 10. 2015
- Here we review the facing & turning we talked about in the first video along with some methods to perform these functions slightly faster. At the end we show the wrong way to drill to hole, and why starter bits should be used for accuracy.
- Jak na to + styl
See a lot of wrongs here. Moving on.
do you use a sherline lathe?
Is that stainless steel?
Just 6061 aluminum. I use aluminum in most of my tutorial videos because it is low cost and very beginning for learning on. I have done some steel and brass on video... don't think I've used stainless steel in any videos yet.
I see you unconventionally face cut from center outwards. why do you prefer this?
Too bad this channel is off line: I was wondering about that also.
That machine is just too flimsy.
So much wrong with this video