Earthing and bonding part 2: How to test continuity of protective conductors

Hello and welcome to part 2 of this video on earthing and bonding conductors.
This part aims to teach you how to test the conductors, what parallel ways actually are, and why it's important to remove them.
Part 3 of this video will move on to fault finding and rectification, before talking you how to record the results in the AM2 or CG2391 inspection and testing qualification.

[@TheFella172]

Make sure you watch these videos in sequential order as this will give you a clear understanding of what, how and why this is required in this extremely important subject as part of your electrical learning journey. Adrian has produced these high quality, visual and understandable set of videos that you can watch over and over again. Brilliant!

[@Pure_electrical_training]

Thank you so much for your kind words 🤗

[@mrpoo7651]

Gotta say, your videos are so helpful. Thank-you bud

[@Pure_electrical_training]

You are very welcome 🤗

[@Rossisearle]

Great video
Disclaimer is so true.. massive respect to you standing your ground for our future generations.
Iv work for a few guys and found out they were domestic installers and they were so BAD I had to walk away, many reasons
Poor workman ship
Not putting buzz bar in correct/fire
Not testing anything
Incorrect polarity supply
Not connecting up in light circuits with LAP shit spot lights
Poor isolation ( 2 near miss's on my self because of them)
Don't uses bs7671
And many more, just don't give a fuck just fast money
Taken many photo to cover my back
I have worked in domestic for 7 years and I love it still but i want to learn more and push my self because I know I'm good,
Iv done
2365 level 2
2365 level 3
18th
Part P
Going to go and do my 2391-52 in July
Then start my NVQ but need to get more commercial training ect

[@Pure_electrical_training]

Thank you 🙏
Keep pushing and good luck.
As they say, the cream always floats to the top 🙌

[@teoscott1]

Thanks a lot for sharing the videos. Was looking for same. best Teacher.
1 suggestion: If possible to decrease the introduction animation for pure electric. the sound is just too high at start and then the voice is normal. Thanks.

[@Pure_electrical_training]

Thank you, I’ll make a note about the animation for the intro and check the volume,
I really appreciate feedback like this 👌

[@Rossisearle]

I have question, delete if don't want to reply
If I was to apply for NICEIC CPS after my 2391, without NVQ will they turn me down? Or would they say I would need to complete it ASAP??
As I'm self employed and want to go on my own

[@Pure_electrical_training]

They will sell you a course to get it and it will be done quick

[@Rossisearle]

@@Pure_electrical_training ok mate...££

[@samanadam2442]

Thanks ❤

[@Pure_electrical_training]

You’re welcome 🙏

[@michaelcostello6991]

Why is the PE of appliance not enough. Why need a main bond on the pipe supplying it ?