I can't find any decent information about P1-44 and P1-45 (gear ratio). I've noticed there are 2 screens on each parameter which look like this _ _ _ _ _ and _ _ _ _ . _ I want to set 1280000 on P1-44 and I'm told that P1-45 should be 1152. This gives me an alarm for gear ratio. I think I might be setting this up incorrectly, because when I set P1-45 as follows, it doesn't work: _ _ _ _ _ 1152.0 Should I be setting it as: _ 1 1 5 2 _ _ _ _ . _ Any help would be much appreciated but I understand if you're busy. Thanks for the video
Im getting Al009 alarm on the drive i took the motor out to make sure encoder motor wiring was ok and it work the motor runs without giving an alarm but never stops since it never gets to see home position once we put the motor back gives the same alarm idk if its mechanical or settings are not correct i dont know what else to do hope you can help
How can i turn on the servo motor. Im uding delta asda-a2. At the display of the servo drive is 00000. And on our hdmi didplay of the machine the servi is didable.when i press enable its not working..pls. give any idea to power on the srrvo..thankyou
Well done sir
I can't find any decent information about P1-44 and P1-45 (gear ratio).
I've noticed there are 2 screens on each parameter which look like this _ _ _ _ _ and _ _ _ _ . _
I want to set 1280000 on P1-44 and I'm told that P1-45 should be 1152. This gives me an alarm for gear ratio.
I think I might be setting this up incorrectly, because when I set P1-45 as follows, it doesn't work:
_ _ _ _ _ 1152.0
Should I be setting it as:
_ 1 1 5 2 _ _ _ _ . _
Any help would be much appreciated but I understand if you're busy.
Thanks for the video
Im getting Al009 alarm on the drive i took the motor out to make sure encoder motor wiring was ok and it work the motor runs without giving an alarm but never stops since it never gets to see home position once we put the motor back gives the same alarm idk if its mechanical or settings are not correct i dont know what else to do hope you can help
al 006 or 009 is normally overload or not moving, you can increase torque from 100% up to 300% but most important is to fix any mechanical issues
how to set speed sir
Mr, I need your help. I have a problem with the servo motor, I wish you could help me 🙏🏻
Hi Hussein, I did not see any replies for some reason, what is the problem you have?
How can i turn on the servo motor. Im uding delta asda-a2. At the display of the servo drive is 00000.
And on our hdmi didplay of the machine the servi is didable.when i press enable its not working..pls. give any idea to power on the srrvo..thankyou
Hi, Check our video on Delta Jog,
hello sir i have need help sir my blister pack machine servo not working me so how can set servo kindly tel
me
Which model servo is it? we mostly work on sheetmetal machines especially press brakes
Can you please help me that how to upgrade drive?
have you got a shematic of the current installation?
@@cncautomotion yes can we connect on whatsapp?
@@praveenajmera4042 do you have email or Skype is better.....
I need solution al022, plz help
Hi Kostas, I dont have experience with AL22, do you have a Delta manual? if not , I can help you
@@cncautomotion now i fixed, all022 means to lose one phase. Thank you for your reply