PLC to Drive communication using tia portal software l TIA portal l Siemens

In this video i show you how to communication process configure between PLC 300 series and G120 series drive using profinet protocol in TIA portal software.

[@jobsinpakandgulf621]

Informative

[@karoliczanwojtylanu]

I think I have already watched this video, but without your voice. Have you recorded it one more time? It is way better to understand now, thanks a lot!

[@mdmahtabalam925]

well explained sir. sir have any demo drive software for practice through my laptop. just like plc simulation software.

[@gyaneshwarchouhan7618]

Dear sir, can you make a video for.....how we can check the communication is healthy between PLC and drive .
And How we can get a indication of this communication is "ok" on hmi

[@dennisshatov9836]

Why did you not use peripheral output between the plc and the VFD? (%MW20 to PQW52) ?

[@richardkeegan358]

Hi, could you please tell me where you got these test stations from? I would like some for our workplace. Thanks

[@tahamohammed4760]

I would like to know where is your training center and the website

[@allaboutindustrialautomati7167]

We have provide training in Ahmadabad,Gujarat.And also we provide online training.

[@tahamohammed4760]

+Techsystems Automation Solution okay please send me your Company website and contact number

[@tarnumlordemmanuel8200]

How one enrols on the online training with you.@@allaboutindustrialautomati7167

[@tarnumlordemmanuel8200]

How can I enrol in the online training

[@vorapobautomation9760]

How about S120 with S7-1200 Can you show please ?

[@allaboutindustrialautomati7167]

Sure sir i will upload latter.

[@raheels.1068]

Hi sir I know you busy iwas write you email also.