Video není dostupné.
Omlouváme se.

Ford Throttle Position Sensor Installation Tips

Sdílet
Vložit
  • čas přidán 4. 01. 2021
  • Watch this video for tips when installing a Throttle Position Sensor on a Ford engine.
    Vehicle used: Mid-2000 Ford 5.4L or 4.6L engine
    Part number installed: TH381
    The part depicted in this video may fit other vehicle applications, and installations may vary from application to application. Certain vehicles may require different, more or fewer steps. Follow all safety precautions and procedures recommended by the vehicle manufacturer prior to servicing the vehicle. Pay special attention to all warnings and safety systems involved in this repair. Review the disclaimer at the close of this video.
    To learn more, visit: www.StandardBrand.com

Komentáře • 12

  • @benflores7032
    @benflores7032 Před 2 lety +1

    thanks for showing how to set my tps sensor i see i put mine not right it had no spring movement mow your video showed me how to install it right its ok now thanks again one bear

  • @thegreenworldch962
    @thegreenworldch962 Před 3 měsíci

    Thanks most helpful tps video

  • @STACKMONEYification
    @STACKMONEYification Před 3 lety

    Do know the symptoms of a bad tps sensor ma o6 4.6 f150 keeps dieing wen i get to a lighy or if i make turns n when immon idle it seems like it wants to cutt off

  • @MrMaster2262
    @MrMaster2262 Před 4 měsíci

    I'm glad i came across this video
    I would of been the forcer 😂
    Extremely helpful... Many Thanks 😉👍

  • @duroka787delapeli
    @duroka787delapeli Před 10 měsíci

    So i took one off. It sounds loose inside when I shake it. Is that normal?

  • @kilvapkram4302
    @kilvapkram4302 Před 2 lety +1

    I've been told Ford uses a lot of locktight,.....bolts are cheap and snap easily.
    I have a 2001 Mercury Sable LS,.....Gonna try to replace TPS this weekend without throwing a fit?
    Gonna do it with throttle body on car.

    • @accorsistudios
      @accorsistudios Před rokem

      I am on here because of this problem. I snapped both right off after being careful (I tried at least). I'm looking for the bolt size I luckily snapped the heads off and could put some small bolts on that I had to re-thread... thus I don't know the diameter and length of the stock bolts. Guessing people are thread locking the heck out of them after installation?

  • @genericdude6551
    @genericdude6551 Před 2 lety +1

    Wouldn't cleaning the throttle plate fix a bad position indication?

    • @bangyahead1
      @bangyahead1 Před 2 lety

      No. Did that and it didnt work.

    • @genericdude6551
      @genericdude6551 Před 2 lety

      @@bangyahead1 Apparently not. I even replaced the TPS and it still reads 20% at idle. It's some kind of law in the computer system.

  • @miguelgarcia3178
    @miguelgarcia3178 Před 3 lety +1

    Hey that makes tour f150 like not accelerate bc i bought a 25 dollar amazon tps and my truck is like no power at all and it doesnt run well and i have to go a 45 and the ln it goes normal